Abstract:Friction significantly influences chip formation, thereby highlighting its modeling critical in numerical cutting simulations. Notably, issues like the underestimation of feed force in simulations are often attributed to inadequate friction models. Nevertheless, diverse conclusions in the literature regarding friction's behavior complicate the accurate implementation of this input. Additionally, the enormous of the available friction models and their varied calibration methods introduce further debates over which aspects of friction modeling should receive more focus. These controversies and deficiencies hinder progress in further understanding friction's role in chip formation through numerical studies. Instead of proposing or calibrating new friction models, the current study, based on Ti6Al4V machining simulations, attempts to readdress the aforementioned controversies in a neutral stance by conducting sensitivity studies using a hybrid Smoothed Particle Hydrodynamics (SPH) - Finite Element Method (FEM) solver with Graphics Processing Units (GPU) acceleration, which is capable of efficiently executing high-resolution computations. The significant impact of friction particularly at the end of the tool-chip contact on the chip formation, physical contact states and process forces are highlighted. The behaviors of physical parameters including normal contact pressure, sliding velocity, and temperature-dependent friction models in the literature are also evaluated. Several aspects such as the shear flow stress limit, the relationship between friction and process forces, and the selection of different models are discussed. In conclusion, pragmatic recommendations for friction modeling and cutting simulation work are provided. On the one hand, the available complex physical parameter dependent friction models could not prove their necessity and should be approached cautiously. Instead, the constant Coulomb friction model without the shear stress limit, despite its simplicity, demonstrates effective and sufficient for a single set of metal cutting simulations. On the other hand, reliable on-site measurement techniques of the coefficient of friction (COF) at the tool-chip sliding contact area should be developed, with consideration of the contact length and the state of material flow. Combined with careful cutting edge preparation and suitable constitutive models, the overall accuracy of numerical cutting simulations including the feed force prediction are expected to be improved.

Modeling of contact stress and tool-based frictional forces considering edge effect through material separation exploration

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

On the Steady-State Workpiece Flow Mechanism and Force Prediction Considering Piled-Up Effect and Dead Metal Zone Formation

Molecular Dynamics Simulation of Elastic–plastic Deformation Associated with Tool–workpiece Contact in Force Sensor–integrated Fast Tool Servo

Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining

Multi-physics analytical modeling of the primary shear zone and milling force prediction

Investigation of friction modeling on numerical Ti6Al4V cutting simulations

Investigation of the tool flank wear influence on cutter-workpiece engagement and cutting force in micro milling processes

Mechanism and force modeling for cross-edges in the flank-end milling process based on the constrained cutting theory

Generic Cutting Force Modeling Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling

Analytical modeling of milling residual stress under different tool wear conditions

Coupled Thermo-mechanical Model for Metal Orthogonal Cutting Process and Finite Element Simulation

Research on Cutting Edge form Factor of Milling Tool after Drag Finishing Preparation Based on Discrete Element Method

Research on the mechanism of tool-workpiece coupling contact and theoretical modeling of surface roughness in turning brittle materials

Numerical model of unidirectional CFRP in machining: Development of an amended friction model

Three-dimensional turning force prediction based on hybrid finite element and predictive machining theory considering edge radius and nose radius

FEM Analysis of Residual Stress Distribution and Cutting Forces in Orthogonal Cutting with Different Initial Stresses

Prediction of residual stress with multi-physics model for orthogonal cutting Ti-6Al-4V under various tool wear morphologies

Friction behaviors in the metal cutting process: state of the art and future perspectives

Finite element simulation of cutting process under the worn tool edge geometries