Abstract:The research and development of compact repetitive miniature plasma focus devices, with stored energy from few tens to few hundred joules, is becoming increasingly important because of their potential applications as portable neutron source for explosive and contraband material detection. In this paper, we report the neutron emission results from our most updated version of Fast Miniature Plasma Focus device, namely FMPF-3. The FMPF-3 (2.4 µF, 34 nH, 103 kA @ 14.0 kV, T/4 ∼460 ns) is an advanced prototype of previous versions of FMPF series which achieves higher performance through the use of four parallel pseudo-spark gap switches for each module instead of single switch used in FMPF-2. This lead to the lower system impedance and hence higher discharge current with further enhancement in neutron to record time average yield of (1.2±0.2)×107 neutrons/sec at 10Hz operation. The analysis of experimental data for plasma focus devices with stored bank energies of 400 J to 1 MJ showed the neutron yield scaling with peak discharge current as Yn∼I3.9. The scaling law at the lower energy limits of 120 – 235 J for FMPF-3 was found to scale on higher side as Yn∼I6.9. The shot to shot stability of neutron emission was tested at different repetition rates from 1 to 10 Hz for shot sequence of 50 shots. It was realized that if the device is operated at the pressure optimized for single shot operation then the neutron yield decreases monotonously after about 30 shots. The increase in operating deuterium pressure lead to the stabilization of neutron yield for 50 shot sequence for repetitive operations. In addition to above results, the paper will also discuss briefly the conceptualization and development of FMPF-3, along with key technical and physical issues and challenges encountered.

High-frequency Wide Beam Underwater Transducer Based on 1–3 Piezocomposite

Wideband and wide beam piezoelectric composite spherical cap transducer for underwater acoustics

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Study of 1-3-2 type piezoelectric composite transducer array

Design simulation and analysis of deep-sea transducer

3-D Underwater Acoustic Wave Focusing by Periodic Structure

Wide band underwater acoustic transducer for stacked 2-2 piezoelectric composite material tube

Planar acoustic transducer and underwater ultrasonic wireless energy transmission

A High-Performance Flexible Hydroacoustic Transducer Based on 1-3 PZT-5A/Silicone Rubber Composite

High performance repetitive low energy miniature plasma focus neutron source: Record yield, scaling laws and yield stability

Research and fabrication of bimetallic plate transducer based on finite element analysis

Beam Characteristics of Ultrasonic Transducers for Underwater Marine Use

Design of Piezoelectric Ultrasonic Transducer Based on Doped PDMS

Finite element method simulation, design, and fabrication of micromachined high-frequency piezoelectric composite with hexagonal pillars for intravascular ultrasound imaging

High-Performance Broadband Bistatic Piezoelectric Composite Array for Application in Ship Wake Detection

Feasible Optimization and Fabrication of Multi-dimension Composites for High Frequency Ultrasonic Transducer

Increasing Performances of 1–3 Piezocomposite Ultrasonic Transducer by Alternating Current Poling Method

Novel multi-layer-composites design for ultrasonic transducer applications

Fabrication of BiScO3–PbTiO3/epoxy 1–3 piezoelectric composites for high‐temperature transducer applications

Investigation of a Multi-Element Focused Air-Coupled Transducer

Fabrication of Radial Array Transducers Using 1-3 Composite via a Bending and Superposition Technique