Abstract:At present, high-speed underwater acoustic communication requires underwater transducers with the characteristics of low frequency and broadband. The low-frequency transducers also are expected to be low-frequency directional for realization of point-to-point communication. In order to achieve the above targets, this paper proposes a new type of flextensional transducer which is constructed of double mosaic piezoelectric ceramic rings and spherical cap metal shells. The transducer realizes broadband transmission by means of the coupling between radial vibration of the piezoelectric rings and high-order flexural vibration of the spherical cap metal shells. The low-frequency directional transmission of the transducer is realized by using excitation signals with different amplitude and phase on two mosaic piezoelectric rings. The relationship between transmitting voltage response (TVR), resonance frequency and structural parameters of the transducer is analyzed by finite element software COMSOL. The broadband performance of the transducer is also optimized. On this basis, the low-frequency directivity of the transducer is further analyzed and the ratio of the excitation signals of the two piezoelectric rings is obtained. Finally, a prototype of the broadband ring flextensional underwater transducer is fabricated according to the results of simulation. The electroacoustic performance of the transducer is tested in an anechoic water tank. Experimental results show that the maximum TVR of the transducer is 147.2 dB and the operation bandwidth is 1.5-4 kHz, which means that the transducer has good low-frequency, broadband transmission capability. Meanwhile, cardioid directivity is obtained at 1.4 kHz and low-frequency directivity is realized.

Wideband and wide beam piezoelectric composite spherical cap transducer for underwater acoustics

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Design simulation and analysis of deep-sea transducer

Wide band underwater acoustic transducer for stacked 2-2 piezoelectric composite material tube

Study of 1-3-2 type piezoelectric composite transducer array

A Real-Time 3-D Underwater Acoustical Imaging System

High-Performance Broadband Bistatic Piezoelectric Composite Array for Application in Ship Wake Detection

Research and Fabrication of Broadband Ring Flextensional Underwater Transducer

Wideband and Wide Beam Polyvinylidene Difluoride (PVDF) Acoustic Transducer for Broadband Underwater Communications †

Beam Characteristics of Ultrasonic Transducers for Underwater Marine Use

Planar acoustic transducer and underwater ultrasonic wireless energy transmission

A High-Performance Flexible Hydroacoustic Transducer Based on 1-3 PZT-5A/Silicone Rubber Composite

Research and fabrication of bimetallic plate transducer based on finite element analysis

Low-frequency Directional Wideband Transducer Based on Lead-Free Piezoelectric Ceramics

Design of Piezoelectric Ultrasonic Transducer Based on Doped PDMS

A Fluidics-Based Double Flexural Membrane Piezoelectric Micromachined Ultrasonic Transducer (PMUT) for Wide-Bandwidth Underwater Acoustic Applications

Finite element method simulation, design, and fabrication of micromachined high-frequency piezoelectric composite with hexagonal pillars for intravascular ultrasound imaging

Planar ultrasonic transducer based on a metasurface piezoelectric ring array for subwavelength acoustic focusing in water

Ultra-wideband underwater acoustic transducer with a gradient impedance matching layer

Investigation of a Multi-Element Focused Air-Coupled Transducer

An integral wavy shaped P(VDF-TrFE) transducer for audio directional system