Abstract:This paper presents a single-stage power management unit to boost and regulate a low supply voltage for CMOS system-on-chip (SoC) applications. It consists of low-leakage, enhanced Dickson charge pump (DCP) that utilizes both stage and frequency modulation (FM) techniques to achieve high efficiency and lower area. In addition, the proposed design uses an enhanced stage-switch structure for the charge pump, which significantly reduces the cross-stage leakage. A stage number controller is used to control the gain of the charge pump by changing the number of stages based on the desired output voltage. FM is utilized to further fine-tune the output voltage through a closed-loop control based on a predetermined reference voltage. Silicon measurement results for the four-stage charge pump in 65-nm CMOS technology show a maximum end-to-end efficiency of 66% at an input voltage of 0.7 V and an output power of <inline-formula> <tex-math notation="LaTeX">$27~\mu \text{W}$ </tex-math></inline-formula>. The proposed design achieved more than a <inline-formula> <tex-math notation="LaTeX">$100\times $ </tex-math></inline-formula> reduction in leakage compared to traditional DCP. The system supports a range of load currents between 0.1 and <inline-formula> <tex-math notation="LaTeX">$34~\mu \text{A}$ </tex-math></inline-formula> with a maximum operating frequency of 1.8 MHz. The proposed system supports an input voltage range of 0.55–0.7 V which makes it an excellent candidate for solar and thermal energy-harvesting applications targeting low-power internet-of-things SOC.

A dual-power-path charge pump for solar-energy harvesting

Ultra-low-voltage Low-Power Charge Pump for Solar Energy Harvesting Systems

A High-Efficiency Split–Merge Charge Pump for Solar Energy Harvesting

A high-efficiency full-wave CMOS rectifying charge pump for RF energy harvesting applications

Wide-Range, High-Precision and Low-Complexity Mppt Circuit Based on Perturb and Observe Algorithm

A regulated charge pump with wide current driving capability for low-voltage applications

A Gain-Controlled, Low-Leakage Dickson Charge Pump for Energy-Harvesting Applications

Optimization Of Microwatt On-Chip Charge Pump For Single-Chip Solar Energy Harvesting

A Low-Voltage Self-Starting Boost Converter Using MPPT with Pulse Multiplication for Energy Harvesting

An Efficient, Wide-Output, High-Voltage Charge Pump With a Stage Selection Circuit Realized in a Low-Voltage CMOS Process

DTMOS-Based Pulse Transformer Boost Converter With Complementary Charge Pump for Multisource Energy Harvesting

A Subthreshold Operation Series-Parallel Charge Pump Incorporating Dynamic Source-Fed Oscillator for Wide-Input-Voltage Energy Harvesting Application

An MPPT-Based Boost Converter with Irridiance-Aware Frequency Selection and Digital ZCS Control for Solar Energy Harvesting

Synchronous Dual-Switch Ultrahigh Step-up DC-DC Converter Based on Coupled Inductor and Voltage Multiplier for Photovoltaic Systems

A Single-Chip Solar Energy Harvesting IC Using Integrated Photodiodes for Biomedical Implant Applications

Research and Design of an On-Chip High Efficiency Dual-Output Charge Pump

Ultra-Low Power Boost Converter with Constant On-Time-Based Mppt for Energy Harvesting Applications

An Efficient Step-up and Step-down Dual-output Charge Pump Controlled by Finite State Machine

A Reconfigurable Multi-Ratio Charge Pump with Wide Input/output Voltage Range for Wireless Energy Harvesting System

A High-Efficiency Dual-Channel Photovoltaic Power System for Nonvolatile Sensor Nodes

A High Step-Up Three-Port DC–DC Converter for Stand-Alone PV/Battery Power Systems