Abstract:In order to efficiently extract power from piezoelectric vibration energy harvesters, various active rectifiers have been proposed in the past decade, which include synchronized switch harvesting on inductor (SSHI), synchronous electric charge extraction (SECE), and so on. Although reported active rectifiers show good performance improvements compared to full-bridge rectifiers (FBRs), large off-chip inductors are typically required and the system volume is inevitably increased as a result, counter to the requirement for system miniaturization. In this paper, a fully integrated split-electrode synchronized switch harvesting on capacitors (SSHC) rectifier is proposed, which achieves significant performance enhancement without employing any off-chip components. The proposed circuit is designed and fabricated in a 0.18- <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> CMOS process and it is co-integrated with a custom microelectromechanical systems (MEMS) piezoelectric transducer with its electrode layer equally split into four regions. The measured results show that the proposed rectifier can provide up to 8.2 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\times $ </tex-math></inline-formula> and 5.2 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\times $ </tex-math></inline-formula> boost, using on-chip and off-chip diodes, respectively, in harvested power compared to an FBR under low excitation levels and the peak rectified output power achieves 186 <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\mu \text{W}$ </tex-math></inline-formula> .

A High-Efficiency Split–Merge Charge Pump for Solar Energy Harvesting

A dual-power-path charge pump for solar-energy harvesting

Ultra-low-voltage Low-Power Charge Pump for Solar Energy Harvesting Systems

A high-efficiency full-wave CMOS rectifying charge pump for RF energy harvesting applications

Optimization Of Microwatt On-Chip Charge Pump For Single-Chip Solar Energy Harvesting

A Reconfigurable Multi-Ratio Charge Pump with Wide Input/output Voltage Range for Wireless Energy Harvesting System

A High-Efficient, Multi-Phase Charge Pump Scheme

A Gain-Controlled, Low-Leakage Dickson Charge Pump for Energy-Harvesting Applications

A Fully Symmetrical Three-port Hybrid Converter for PV Systems

A Compact Dickson Hybrid Boost Converter with 5-Mv Input 90.5% Peak Efficiency and On-Chip Cold-Start for Thermoelectric Energy Harvesting

A Subthreshold Operation Series-Parallel Charge Pump Incorporating Dynamic Source-Fed Oscillator for Wide-Input-Voltage Energy Harvesting Application

A Low-Voltage Self-Starting Boost Converter Using MPPT with Pulse Multiplication for Energy Harvesting

Synchronous Dual-Switch Ultrahigh Step-up DC-DC Converter Based on Coupled Inductor and Voltage Multiplier for Photovoltaic Systems

A Dickson Hybrid Boost Converter With On-Chip Cold-Start for Thermoelectric Energy Harvesting.

A High-Efficiency Dual-Channel Photovoltaic Power System for Nonvolatile Sensor Nodes

An Efficient, Wide-Output, High-Voltage Charge Pump With a Stage Selection Circuit Realized in a Low-Voltage CMOS Process

DTMOS-Based Pulse Transformer Boost Converter With Complementary Charge Pump for Multisource Energy Harvesting

A Fully Integrated Split-Electrode SSHC Rectifier for Piezoelectric Energy Harvesting

A Single-Chip Solar Energy Harvesting IC Using Integrated Photodiodes for Biomedical Implant Applications

Low Voltage Switched-Capacitive-Based Reconfigurable Charge Pumps for Energy Harvesting Systems: An Overview

A Low-Cost and High-Efficiency Integrated Device toward Solar-Driven Water Splitting.