Abstract:Complex and deep cavity features are ubiquitous in industrial parts, where the harsh interference condition necessitates the use of multi-axis machining strategy to rough-machine the raw blank, in a layer-by-layer manner. However, as the cavity is deep, the cutting tool is typically very long, which requires that the cutting force be carefully controlled. This brings much complexity for determining the machining layers because the cutting force is closely related to the cutting depth, feed direction, and tool orientation, which are all tangled with each other. Conventionally, roughing layers are typically created using iso-parametric curves of boundary surfaces, resulting in longer tool path length and underutilization of the tool' s cutting capacity (i.e., in most of the cutting time, the cutting force is below the given threshold). In addition, the tool orientation is usually adjusted to satisfy the collision-free condition only after the tool path has already been generated, which may introduce ragged tool postures and undermine the finish-surface quality. In this paper, for an arbitrary complex and deep cavity defined by a tetrahedral mesh, borrowing the concept of the iso-scallop height method, we propose a general iso-force rough milling algorithm that enlarges the layer distance as much as possible under the preset force threshold to fully utilize the tool' s bearing capacity and improve cutting efficiency, which is signified by the generated intrinsic machining layers as well as the smooth and collision-free tool paths. The crux of the algorithm is the establishment of a smooth and initially non-orthogonal volumetric frame field whose base vectors respectively represent the potential machining layer normal, the feed direction, and the tool orientation at every point in the volume of the cavity, tending to the hard constraint of collision-free. A scalar field of the magnitude of the cutting force is then constructed inside the volume, which is iteratively synchronized with the volumetric frame field. The iso-force machining layers are then progressively sliced from the optimized cutting force scalar field, on which iso-contour tool paths are finally planned. Both computer simulation and physical cutting experiments are carried out, and the experimental results give a positive confirmation of the generality and effectiveness of the proposed method.

Iso-force rough machining of freeform deep cavities based on volumetric fields

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Tool-path planning based on iso-scallop for plunge milling in pocket walls manufacture

The Tool Paths Generation Approach Based on Level-Set Methods in Die-Cavities NC Machining

A feedback toolpath generation method for compound trimmed surface with machine’s dynamic characteristics confined

A Unified Geometrical Modeling and Analysis Method for Evaluating CFRP Machining Performance: Cutting Geometry Space

A new toolpath generation method with feed sensitive zones inspection based on inverse evaluation mechanism.

Mechanistic Modeling of Five-Axis Machining with a General End Mill Considering Cutter Runout

A Multi-Scale Tool Orientation Generation Method for Freeform Surface Machining with Bull-Nose Tool

A generic uniform scallop tool path generation method for five-axis machining of freeform surface.

Collaborative optimization of conical cutter sequence for efficient multi-axis machining of deep curved cavities

Iso-Planar Feed Vector-Fields-Based Streamline Tool Path Generation for Five-Axis Compound Surface Machining With Torus-End Cutters

Multi-physics analytical modeling of the primary shear zone and milling force prediction

Research on tool diameter and processing width optimization for highly efficient machining of complex surfaces constrained by machining interference surface

Efficient 5-Axis CNC Trochoidal Flank Milling of 3D Cavities Using Custom-Shaped Cutting Tools

Computing Smooth Preferred Feed Direction Fields with High Material Removal Rates for Efficient CNC Tool Paths.

Influence mechanism of machining angles on force induced error and their selection in five axis bullnose end milling

Vector Field Based Volume Peeling for Multi-Axis Machining

A New Approach of Modelling Bottom Edge Cutting in 4-Axis Rough Milling of Complex Parts and Its Application on Feed Rate Optimization