3D-Printing Damage-Tolerant Architected Metallic Materials with Shape Recoverability via Special Deformation Design of Constituent Material
Zhiwei Xiong,Meng Li,Shijie Hao,Yinong Liu,Lishan Cui,Hong Yang,Chengbo Cui,Daqiang Jiang,Ying Yang,Hongshuai Lei,Yihui Zhang,Yang Ren,Xiaoyu Zhang,Ju Li
DOI: https://doi.org/10.1021/acsami.1c11226
2021-08-16
Abstract:Architected metallic materials generally suffer from a serious engineering problem of mechanical instability manifested as the emergence of localized deformation bands and collapse of strength. They usually cannot exhibit satisfactory shape recoverability due to the little recoverable strain of metallic constituent material. After yielding, the metallic constituent material usually exhibits a continuous low strain-hardening capacity, giving the local yielded regions of architecture low load resistance and easily developing into excessive deformation bands, accompanied by the collapse of strength. Here, a novel constituent material deformation design strategy has been skillfully proposed, where the low load resistance of yielded regions of the architecture can be effectively compensated by the significant self-strengthening behavior of constituent material, thus avoiding the formation of localized deformation bands and collapse of strength. To substantiate this strategy, shape-memory alloys (SMAs) are considered as suitable constituent materials for possessing both self-strengthening behavior and shape-recovery function. A 3D-printing technique was adopted to prepare various NiTi SMA architected materials with different geometric structures. It is demonstrated that all of these architected metallic materials can be stably and uniformly compressed by up to 80% without the formation of localized bands, collapse of strength, and structural failure, exhibiting ultrahigh damage tolerance. Furthermore, these SMA architected materials can display more than 98% shape recovery even after 80% deformation and excellent cycle stability during 15 cycles. This work exploits the amazing impact of constituent materials on constructing supernormal properties of architected materials and will open new avenues for developing high-performance architected metallic materials.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c11226.Typical secondary hardening behavior of commercial NiTi SMA, stripe rotation scanning strategy used for 3D-printing, preparation procedure of 3D-printed NiTi tensile samples, XRD spectrum of 3D-printed NiTi alloy, comparison of the tensile properties of 3D-printed NiTi and machined NiTi alloy, tensile stress–strain curves of three different constituent materials, compression deformation behavior of the 3D-printed Al honeycomb, compression deformation behavior of the 3D-printed NiTi multicell honeycomb, compression deformation behavior of the machined Al honeycomb, finite element simulation results, deformation of the representative unit cell, and shape-recovery rates of the NiTi re-entrant negative Poisson ratio structure and octahedral lattice structure (PDF)Compressive deformation comparison of 3D-printed NiTi honeycomb and machined Al honeycomb (MP4)Shape recovery of a 3D-printed NiTi honeycomb upon heating (MP4)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology