Abstract:Electrical stimulation can be used in several applications such as fatigue reduction, muscle rehabilitation, neurorehabilitation, neuro-prosthesis and pain relief. Moreover, electrical stimulation can be used for drug delivery applications or body fluids extraction (e.g., sweat and interstitial fluid) to successively monitor several parameters, such as glucose, lactate, etc. All these applications are performed using electrical stimulator devices capable of applying constant voltage pulses or constant current pulses via electrodes to human tissues. Usually, constant current stimulators are most widely used because of their safety, stability, and repeatability. Thus, the aim of this work was to design, realize and test a mixed-signal electronic interface capable of producing current pulses with custom amplitude, duration, frequency, polarity and symmetry with extended voltage compliance. To achieve this result, we developed a high-voltage current stimulator suitable for iontophoresis applications. Current stimuli can be applied setting the intensity, frequency and duty cycle of the stimulation patterns through a μC. A custom electronic interface was designed to allow the control of the injected current in real time and to prevent electrical injuries to the patient by avoiding potential unwanted short circuits. Moreover, the system was tested in a simulated environment demonstrating its effectiveness and applicability for transdermal monitoring applications. The obtained results show that the device is able to apply monophasic and biphasic pulses, ranging from 0.1 to 10 mA, with a maximum error of about 10% at the minimum intensity; in addition, current stimuli can be applied up to a maximum frequency of 100 kHz with a voltage compliance of 120 V.

Research on Design Method of Voltage Injection Test Circuit of Active Implantable Neurostimulator

General Voltage Injection Device for Immunity Test of Active Implantable Neurostimulators to Electromagnetic Fields over the Frequency Range 16.6hz to 80Mhz

The feasibility of in-vitro testing in ICD implantation procedure

Electrochemical Impedance Behavior of Implantable Neural Interface Following the Change of Equivalent Circuit Element

Simulative and Experimental Research on Wireless Power Transmission Technique in Implantable Medical Device

Electrical Characteristics of A Stimulating Microelectrode-Electrolyte Interface

Primary side control of load voltage for transcutaneous energy transmission

Distribution of Electrical Stimulation Current of a Minimally Invasive Endovascular Stent-Electrode

Impedance spectroscopy analysis of cell-electrode interface.

A High-Voltage, Energy-Efficient, 4-Electrode Output Stage for Implantable Neural Stimulator

The Design and Simulation of Wireless Charging Coil using Maxwell for Implantable Devices

Study of Implantable Single-point Electrical Stimulation System

Design of Multi-channel Electrical Stimulator Integrated with Online Impedance Measurement

Experimental evaluation of optimal-designed neural electrodes based on simulated implantation system

Design and System Verification of Reconfigurable Matching Circuits for Implantable Antennas in Tissues With Broad Permittivity Range

The Wireless Power Transfer System Applied to an Implantable Deep Brain Stimulator

Improving Electrical Stimulation Effectiveness and Versatility for Non-Invasive Transdermal Monitoring Applications via an Innovative Mixed-Signal Electronic Interface

Transcutaneous Coupling Implantable Stimulator

Feedback System for Artificial Electrical Prosthesis Based on In-vivo Impedance Measurement

DC–DC Converter Design with Ferrite Core Inductor for Implantable Neurostimulation Device Compatible with MRI

Design and Analysis of a Transcutaneous Telemetry Device for Brain Stimulator