Abstract:The direct synthesis of adipic acid from hydrogen peroxide and cyclohexene was investigated in capillary microreactors at high temperature (up to 115 degrees C) and pressure (up to 70 bar): High temperature was already applied in microflow packed-bed reactors for the direct adipic acid synthesis. In our previous work we showed that the process suffered from unavoidable gas generation due to hydrogen peroxide decomposition when working at low pressure. Herein, we used a high pressure strategy to-minimize hydrogen peroxide decomposition. Huge hotspots were observed inside a microflow packed-bed reactor under high pressure conditions. Capillary microreactors display a better heat transfer efficiency and thus may provide abetter alternative for scaling-up. Consequently, capillary microreactors were selected for the.reaction; rocess with high pressure. One assisting element is the addition of phosphoric acid which is generally known to reduce the decomposition of H2O2. The use of phosphoric acid had a positive influence on the isolated yield. We could improve-the yield further by increased interfacial mass transfer between the organic and aqueous slugs, when increasing the flow rate while keeping the same residence time. A further gain was given by using the of 2-stage temperature ramping strategy which we recently introduced for the niicroflow packed bed reactor. Applying all these aspects led to a maximum yield, of 59% at 70-115 degrees C and 70 bar. The stabilizing effect of phosphoric acid on H2O2 is more obvious in a the 2-stage temperature ramping scenario as in a single temperature operation. In addition, channel clogging by adipic acid precipitation in the microreactor was observed. Therefore, several useful strategies were proposed to prevent channel clogging at high temperature and pressure.

Two-Stage Temperature Control for the Synthesis of Adipic Acid Through K/A Oil Oxidation in a Microreactor System

Synthesis of Adipic Acid Through Oxidation of K/A Oil and Its Kinetic Study in a Microreactor System

Kinetic Study on the Reaction Routes in the Oxidation of K/A Oil by Nitric Acid with Microreactors

Effects of Process Conditions on Products Distribution of Cyclohexane Non-Catalytic Oxidation in Microcapillary

Coating of Au-Al2o3 Catalyst in the Wall of Microcapillary and Its Application in Cyclohexane Oxidation

Modeling and Optimization for Industrial Adipic Acid Synthesis Reactors

Numerical Modeling of a Microreactor for the Synthesis of Adipic Acid Via KA Oil Oxidation

Synthesis of N, N-dimethyl-n-butylamine with Tubular Reactor

Kinetic Study for the Oxidation of Cyclohexanol and Cyclohexanone with Nitric Acid to Adipic Acid

Hydrodynamics of a Fast and Highly Exothermic Liquid-Liquid Oxidation Process with In-Situ Gas Production in Microreacto

High Pressure Direct Synthesis of Adipic Acid from Cyclohexene and Hydrogen Peroxide via Capillary Microreactors

Introduced gas regulating fast and highly exothermic reactions with in situ gas generation in microreactors

2- and 3-Stage temperature ramping for the direct synthesis of adipic acid in micro-flow packed-bed reactors

Highly Efficient Nano-Catalysts Using Activated Carbon As a Support for One-Step Oxidation of Cyclohexane to Adipic Acid

Accelerated Two-Phase Oxidation in Microdroplets Assisted by Light and Heat Without the Use of Phase-Transfer Catalysts

Electrocatalytic synthesis of adipic acid coupled with H2 production enhanced by a ligand modification strategy

Directional Electrosynthesis of Adipic Acid and Cyclohexanone by Controlling the Active Sites on NiOOH.

A novel way of liquid phase oxidation of toluene to benzaldehyde with improved selectivity

Optimization of Adiponitrile Hydrolysis in Subcritical Water Using an Orthogonal Array Design

Continuous Cu/keto-ABNO catalyzed aerobic oxidation of ethyl lactate to ethyl pyruvate in a micro-packed bed reactor: Process optimization and reaction kinetics

Effect of Acetic Anhydride on the Oxidation of Toluene to Benzaldehyde with Metal/Bromide Catalysts