Abstract:Surface defects are prevalent in natural rock masses, and the newborn cracks that initiate from these defects and significantly affect structural stability usually extend in a three-dimensional (3D) manner. Hence, in this research, a series of uniaxial compression tests were conducted on sandstone specimens containing a surface flaw to examine the effect of nondimensional flaw depth (0, 0.3, 0.5 and 0.75) on the fracture behavior. The crack propagation process was monitored by digital image correlation (DIC) technique, and postmortem microscopic fracture morphology was measured using scanning electron microscope (SEM) method. In addition, the fracture energy evolution and stress intensity factors (SIFs) along the semi-elliptical flaw perimeter were discussed in detail to theoretically interpret the experimental phenomena. The results indicate that the strength decreased by 2.70%, 10.90% and 11.91% for nondimensional surface flaw depths of 0.3, 0.5 and 0.75, respectively, and elastic modulus exhibited a reduction of 3.71%, 10.69% and 3.21%, respectively. Full-field deformation contours demonstrate that crack paths in the front surface of the specimen were totally different from those in the back surface, but the failure pattern tended to be similar to that of specimens containing a penetrated flaw with the increasing flaw depth. The micro appearance of a typical fracture further reveals the complicated stress state (mixed I-II-III mode) under uniaxial compression. For a larger flaw depth, the proportion of releasable elastic strain energy in total input strain energy was improved, while the percentage of dissipated energy was reduced. Based on fracture mechanics, SIFs along the flaw periphery uncover the magnitude of KI, KII and KIII and further the type of initiation crack type. Finally, parametric analysis was carried out to investigate the effects of flaw length and specimen thickness. The difference in crack pattern from surface and penetrated flaw was also discussed in detail.

Experimental And Numerical Study On Strength And Deformation Behaviors Of Sandstone With Intersecting Flaws

Experimental and DEM study on failure behavior and stress distribution of flawed sandstone specimens under uniaxial compression

Numerical Study of the Strength and Characteristics of Sandstone Samples with Combined Double Hole and Double Fissure Defects

Cracking Behavior and Acoustic Emission Characteristics of Rock Containing a Single Preexisting Flaw

Fracture behavior of cylindrical sandstone specimens with two pre-existing flaws: experimental investigation and PFC3D simulation

Mechanical Behaviours of Sandstone Containing Intersecting Fissures under Uniaxial Compression

Experimental investigation on mechanical behavior of sandstone with coupling effects under uniaxial compression

Experimental study of the effect of crack distribution on the failure mechanism of sandstone specimens based on inclination angles and number of parallel flaws

Numerical investigation on the influence of secondary flaw lengths on the mechanical characteristics and cracking behaviour of red sandstone containing orthogonal cross flaws

Mechanical Behavior and Failure Analysis of Brittle Sandstone Specimens Containing Combined Flaws under Uniaxial Compression

Experimental and numerical study on the mechanical behaviors and crack propagation of sandstone containing two parallel fissures

3D spatial fracture behavior of sandstone containing a surface flaw under uniaxial compression

Experimental investigation on mechanical, acoustic, and fracture behaviors and the energy evolution of sandstone containing non-penetrating horizontal fissures

A Numerical Study On The Crack Development Behavior Of Rock-Like Material Containing Two Intersecting Flaws

Internal Stress Distribution and Cracking Around Flaws and Openings of Rock Block under Uniaxial Compression: A Particle Mechanics Approach

Experimental Study on the Dynamic Behavior of Sandstone with Coplanar Elliptical Flaws from Macro, Meso, and Micro Viewpoints

Failure Behavior of Sandstone Specimens Containing a Single Flaw Under True Triaxial Compression

Experimental Study of the Mechanical and Fracture Behavior of Flawed Sandstone Subjected to Coupled Static-Repetitive Impact Loading

Study on energy damage evolution of multi-flaw sandstone with different flaw lengths

Experimental Study on Mechanical Properties and Failure Characteristics of Sandstone Containing a Pre-Existing Surface Flaw under Dynamic Loading

Discrete element modeling on crack evolution behavior of sandstone containing two oval flaws under uniaxial compression