Enhanced Hydrogen Production by the Catalytic Alkaline Thermal Gasification of Cellulose with Ni/Fe Dual-Functional CaO Based Catalysts

Xi Zeng,Mengxiang Fang,Tong Lv,Jianglei Tian,Zhixiang Xia,Jianmeng Cen,Qinhui Wang
DOI: https://doi.org/10.1016/j.ijhydene.2021.07.142
IF: 7.2
2021-01-01
International Journal of Hydrogen Energy
Abstract:A two-stage system involving alkaline thermal gasification of cellulose with Ca(OH)(2) sorbent and catalytic reforming with Ni/Fe dual-functional CaO based catalysts is proposed and applied to enhance H-2 production and in-situ CO2 capture. The results show that the H-2 concentration is maximized at a considerably lower temperature (500 degrees C) than commercialized biomass gasification processes, reducing energy consumption. Sol-gel method is deemed better than impregnation method for its lower cost and higherconcentration H-2 production. Among the prepared catalysts, sol-NiCa catalyst exhibits the best performance in CO2 absorption, resistance to carbon deposition, and cyclic stability, creating maximum H-2 concentration (79.22 vol%), H-2 yield (27.36 mmolg(-1) cellulose), and H-2 conversion (57.61%). Introduction of Ni rather than Fe on the CaO based catalyst promotes steam methane reforming at moderate temperature range of 400-600 degrees C, generating low contents of CH4 (5.38 vol%), CO2 (4.82 vol%), and CO (10.58 vol%). (C) 2021 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?