Abstract:Lithium-rich layered oxides have attracted much attention due to their high discharge capacity (>250 mA h·g–1). However, lithium-rich layered cathodes suffer from poor rate capabilities and voltage decay, which seriously limit their practical application. Herein, a unique @spinel double-spinel shell heterostructure is designed and successfully synthesized via coprecipitation and high-temperature solid-phase methods. In particular, lithium-rich layered oxides show good rate capabilities and high capacity retention when the molar amount of cobalt acetate and manganese acetate is 5%. After 100 cycles at 0.2 C, a discharge capacity of 232 mA h g–1 and a capacity retention of 92.7% can be obtained. The superior electrochemical performance of the in situ-transformed Li-rich layered cathode can be attributed to the unique three-dimensional diffusion channels for Li ions of the surface spinel phase. Besides, the in situ-transformed LiCoMnO4 shell can also improve the structural stability of the Li-rich layered oxides by reducing the side reactions and protecting the material from being corroded by the electrolyte. This study provides a strategy for surface modification, which can effectively improve the electrochemical performance of Li-rich layered cathode materials with high performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01955.SEM image of the precursor Ni1/6Co1/6Mn4/6CO3 and the corresponding mapping spectrum; ex situ XRD spectra of the LLO and LSS-0.05 samples; EDS line scan of the selected area and the corresponding HTEM diagram of the LSS-0.05 sample; CV and dQ/dV curves of the first three cycles of the LLO, LSS-0.05, and LSS-0.1 samples; initial charge and discharge curves of LiCoMnO4, LSS-0.2, and LSS-0.4 samples; discharge curves of LLO, LSS-0.05, and LSS-0.1 samples at different rates and with different cycles; typical single titration curve of GITT measurements; equivalent circuit of half-cells; and EIS spectra of LLO, LSS-0.05, and LSS-0.1 samples in the initial cycle (PDF)This article has not yet been cited by other publications.

Retracted: In Situ Nano-Coating On Li1.2mn0.52ni0.13co0.13o2 With A Layered@Spinel@Coating Layer Heterostructure For Lithium-Ion Batteries (Retracted Article. See Vol.4,Pg.14884,2016)

Enhanced electrochemical performance of Li 1.2 Mn 0.54 Ni 0.13 Co 0.13 O 2 cathode material coated with Li + -conductive Li 2 SiO 3 for lithium ion batteries

Improved Electrochemical Performances of Li- and Mn-Rich Layered Oxides 0.4li4/3mn2/3o2·0.6lini1/3co1/3mn1/3o2 Cathode Material by Co3O4 Coating

Layered/Layered Homostyructure Ion Conductor Coating Strategy for High Performance Lithium Ion Batteries

Enhanced Electrochemical Performance of Li[Li0.2ni0.2mn0.6]O-2 Modified by Manganese Oxide Coating for Lithium-Ion Batteries

Performance Improvement of Li-rich Layer-Structured Li1.2Mn0.54Ni0.13Co0.13O2 by Integration with Spinel LiNi0.5Mn1.5O4

Bulk and surface reconstructed Li-rich Mn-based cathode material for lithium ion batteries with eliminating irreversible capacity loss

Effect of carbon coating on electrochemical performance of Li 1.048 Mn 0.381 Ni 0.286 Co 0.286 O 2 cathode material for lithium-ion batteries

Inverse Spinel-Structured Mg2MnO4 Coating to Enable Superior Thermal Stability of LiNi0.83Co0.12Mn0.05O2 Cathodes for Lithium-Ion Batteries

Retraction: In situ nano-coating on Li<sub>1.2</sub>Mn<sub>0.52</sub>Ni<sub>0.13</sub>Co<sub>0.13</sub>O<sub>2</sub> with a layered@spinel@coating layer heterostructure for lithium-ion batteries

Improving the Electrochemical Performance of a Lithium-Rich Layered Cathode with an In Situ Transformed Layered@Spinel@Spinel Heterostructure

Lithium-Rich Li1.2ni0.13co0.13mn0.54o2 Oxide Coated By Li3po4 And Carbon Nanocomposite Layers As High Performance Cathode Materials For Lithium Ion Batteries

Enhanced Electrochemical Performance of Li1.2mn0.54ni0.13co0.13o2 Cathode with an Ionic Conductive Livo3 Coating Layer

Improved Electrochemical Performance of Li-Rich Cathode Materials via Spinel Li2MoO4 Coating

Substantial Doping Engineering in Layered LiNi0.5+xCo0.2−xMn0.3O2 Materials for Lithium-Ion Batteries

Suppressing the Structure Deterioration of Ni-Rich LiNi0.8Co0.1Mn0.1O2 Through Atom-Scale Interfacial Integration of Self-Forming Hierarchical Spinel Layer with Ni Gradient Concentration

The Enhanced Electrochemical Performance of Li1.2Ni0.2Mn0.6O2 Through Coating MnF2 Nano Protective Layer

Substantial Doping Engineering in Layered LiNi 0.5+x Co 0.2−x Mn 0.3 O 2 Materials for Lithium-Ion Batteries

Reinforcing the Stability of Cobalt-free Lithium-rich Layered Oxides via Li-poor Ni-rich Surface Transformation

Synthesis and Electrochemical Properties of Co,Mn-Coated Linio2 Lithium-Ion Battery Cathode Materials

Beneficial Effects of La0.5Sr0.5CoO3 Coatings on Thin‐Film LiMn2O4 Cathodes for Lithium Ion Batteries