Abstract:<p>The injection molding process is widely used for the mass production of plastic parts. However, as product designs become lighter, thinner and smaller, and the allowable tolerances shrink, the need to improve the quality consistency of the injection molding process has emerged as a critical concern. In mass production, injection molding is typically performed using fixed settings of the machine inputs. However, in practice, the properties of the plastic melt invariably change from batch to batch and even from shot to shot. Consequently, the use of fixed parameter settings fails to guarantee the stability of the molded part quality. Existing quality monitoring and control systems for the injection molding process are often based on pressure information. However, obtaining this information generally requires the installation of pressure sensors within the molding cavity, which is not only expensive and time-consuming, but may also interfere with the injection molding process itself. Accordingly, the present study proposes a quality monitoring and control system for injection molding processes based on the tie bar elongation measurements obtained using a strain gage. In the proposed approach, variations in the tie bar strain characteristic are taken to indicate deviations in the process stability and are used to manipulate the processing parameters accordingly in order to ensure the stability and consistency of the molded part quality. The feasibility of the proposed approach is demonstrated by performing injection molding trials with a two-cavity mold designed to produce tensile test specimens. The experimental results show that the quality of the molded parts varies significantly with the injection speed, velocity-to-pressure (V/P) switchover point, holding pressure, and melt temperature. Among these four parameters, the V/P switchover point and holding pressure induce a particularly rapid dynamic response, and thus provide an effective means of compensating for process deviations from shot to shot. By changing the melt temperature to simulate environmental noise, it is shown that the two parameter settings enable the consistency of the part weight to be restored to a range of 0.01 g within six shots. Moreover, the yield rate is enhanced from 60% to 90%.</p>

A Transparent Barrel For Study Of Reciprocationg Screw Injection Molding

A visual barrel system for study of reciprocating screw injection molding

Visualization Study of the Piastication During Injection Molding (Ⅰ)

In-line measurement apparatus for residence time distribution in twin-screw extruder and its application in polymer processing

Evolution of residence time distribution and fill degree in co-rotating twin-screw extruder

Finite Element Analysis and Optimal Researchon Plasticizing Capacity of Screws

Qualitative study on intermeshing co-rotating twin screw extrusion using novel visual technique

An Experimental Study of Solid‐bed Break‐up in Plasticization of a Reciprocating‐screw Injection Molding

High-Throughput in Situ Characterization of Polymer Crystallization under an Intense Flow, High Pressure, and Cooling Gradient during Injection Molding

Study of Performance of Novel Injection Screw

Study on Computer Simulation of Co-injection Molding

A real-time process optimization system for injection molding

A Novel Apparatus Combining Polymer Extrusion Processing and X-Ray Scattering

Study of Residence Time Distribution in a Reciprocating Single-Screw Pin-Barrel Extruder

Enhancing the quality stability of injection molded parts by adjusting V/P switchover point and holding pressure

In-Line Chemical Composition Monitoring for the Injection Molding Process of Biodegradable Polymer Blends Using Simultaneous Measurement of Near-Infrared Diffuse Reflectance and Transmission Spectra

Barrier Screw Design for High-Performance Plasticizing in Injection Molding

New Injection Molding Technology and Development for Polymer Materials

A Nondestructive Online Method for Monitoring the Injection Molding Process by Collecting and Analyzing Machine Running Data

INJECTION MOLDING OF POLYCARBONATE THICK-WALLED PARTS USING A TOOL WITH VARIOUSLY DESIGNED GATE INSERTS

In-situ ultrasonic measurement of molten polymers during injection molding