Abstract:Abstract High-temperature heat pipe is an ideal technical solution for microreactors applied for space missions, planet surface, and the small electricity markets on the ground. However, the internal fluid flow state and the effects of key parameters such as permeability, porosity, and capillary force of wick structure on the distribution of working fluid inside the heat pipe are difficult to measure experimentally. In this study, a general CFD model for heat pipe with wick structure that can predict the thermal behavior at different steady-state conditions was carried out. The thermal conduction through heat pipe shell, liquid film on the inner surface, and the formation of liquid reservoir at the bottom of heat pipe were considered in this model. A high-temperature heat pipe model considering the flow of liquid working fluid inside the wick structure was developed based on the Star-CCM+ numerical simulation software. The model used a combination of the liquid film model and the Volume of Fluid (VOF) model to simulate the effects of fluid flow and collection behavior inside the wick structure on the heat transfer characteristics of the heat pipe. The method included models for flow resistance and capillary driving force under steady-state conditions, centrifugal force and time-varying gravitational field under motion conditions, and mixed convective heat transfer caused by motion conditions. The accuracy of the numerical simulation was validated using typical potassium high-temperature heat pipe experiments. The effects of different permeability and capillary force characteristics of the wick structure on heat transfer and internal fluid distribution in the heat pipe were studied. Based on the current method, high-temperature heat pipes with different inclinations (0°, 90 °and 45°) were investigated. Additionally, non-uniform heating boundary conditions were added to the high-temperature heat pipe evaporator section to investigate its heat transfer performance under real reactor axial power input. This investigation lays the foundation for the design and analysis of the heat transfer characteristics of high-temperature heat pipes.

ELECTROHYDRODYNAMIC MINI FLAT HEAT PIPE FOR ADVANCED ELECTRONICS COOLING

Experimental Investigation on the Active Thermal Management of Grooved Flat Heat Pipe under the Electrohydrodynamic Effect

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Thermal Characterization and Wick Optimization of Mini-Grooved Flat Heat Pipe for Electronics Cooling

Thermal Performance Analysis of Flat Heat Pipe with Graded Mini-Grooves Wick

Theoretical Analysis of Flat Heat Pipe with Graded-Porosity Wick Design

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Characterization of Wicking Performance for Open Rectangular Microgrooves under Planar EHD Effects in Two-Phase Heat Transfer Devices

Experimental and simulation study on flow heat transfer characteristics of flat pulsating heat pipe with wide and narrow interphase channels

Three-Dimensional Numerical Analysis of Mini-Grooved Flat Heat Pipe Filled with Different Working Fluids with Experimental Validation

Experimental investigation on thermal performance of ultra-thin flattened heat pipe with middle heating for electronics cooling

Visualization research on influencing factors of flat heat pipes

Experiments and comparisons of three miniature heat pipes' thermal performance

Mini-scale pulsating heat pipe cooling systems for high-heat-flux electronic equipment

Experimental Studies on a Novel Thin Flat Heat Pipe Heat Spreader

Investigation on Transient Behaviors of Flat Plate Heat Pipes

Fabrication and Performance Evaluation of Flexible Heat Pipes for Potential Thermal Control of Foldable Electronics

Thermal Analysis and Maximum Heat Transport of a Micro Flat Heat Pipe with Axial Triangle Grooves

Numerical Investigation of High-Temperature Heat Pipes with Different Wick Structures under Non-Uniform Heating Boundary Conditions