Abstract:The wicking phenomenon, including wicking and hemiwicking, has attracted increasing attention for its critical importance to a wide range of engineering applications, such as thermal management, water harvesting, fuel cells, microfluidics, and biosciences. There exists a more urgent demand for anisotropic wicking behaviors since an increasing number of advanced applications are significantly complex. For example, special-shaped vapor chambers and heating atomizers in some electronic cigarettes need liquid replenishing with various velocities in different wicking behaviors with elliptical shapes on laser structured prismatic microgrooves. The prismatic microgrooves were fabricated via one-step femtosecond laser direct writing, and the anisotropic hemiwicking behaviors were observed when utilizing glycerol, glycol, and water as the test liquid. Specifically, the ratios of horizontal wicking distance in directions along short and long axes were tan 0 degrees, tan 15 degrees, tan 30 degrees, and tan 45 degrees for samples with cross-angles of 0 degrees, 30 degrees, 60 degrees, and 90 degrees, respectively. The vertical water wicking front displayed corresponding angles under the guidance of laser structured prismatic microgrooves. Theoretical analysis shows that the wicking distance is mainly dependent on the cross-angle 0 and surface roughness, in which the wicking distance is proportional to cos(0/2). Driven by the capillary pressure forming in the narrow microgrooves, the liquid initially filled the valleys of microgrooves and then surrounded and covered the prismatic ridges with laser-induced nanoparticles. The abundant nanoparticles increased the surface roughness, leading to the enhancement of wicking performance, which was further evidenced by the larger wicking speed of the sample with more nanoparticles. The mechanism of anisotropic hemiwicking behaviors revealed in this work paves the way for wicking control, and the proposed prismatic microgrooved surfaces with two-dimensional anisotropic hemiwicking performance and superhydrophilicity could serve in a broad range of applications, especially for the advanced thermal management with specific heat load configurations.

Characterization of Wicking Performance for Open Rectangular Microgrooves under Planar EHD Effects in Two-Phase Heat Transfer Devices

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Wicking capability evaluation of multilayer composite micromesh wicks for ultrathin two-phase heat transfer devices

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Effect of Fabrication Parameters on Capillary Performance of Composite Wicks for Two-Phase Heat Transfer Devices

Enhanced evaporation performance on a novel microstructured surface with vertical dimension gradient

Characterization of capillary performance of composite wicks for two-phase heat transfer devices

Experimental study in thermal expansion devices of phase-change material coupled to vapor chamber with gradient wettability wick

Hierarchically 3D-textured copper surfaces with enhanced wicking properties for high-power cooling

Heat transfer enhancement by electrohydrodynamics in wavy channels

Heat transfer enhancement and flow resistance reduction characteristics of non-uniform electrohydrodynamic conduction pumping in microchannels

Analytical and experimental on the capillary rise of aluminum multi-scale microgroove wick structures

Vapor chamber with two-layer liquid supply evaporator wick for high-heat-flux devices

Anisotropic Hemiwicking Behavior on Laser Structured Prismatic Microgrooves

Ultrathin Aluminum Wick with Dual-Scale Microgrooves for Enhanced Capillary Performance

Superior Heat and Mass Transfer Performance of Bionic Wick with Finger-like Pores Inspired by the Stomatal Array of Natural Leaf

Experimental study on thermal performance of ultra-thin heat pipe with a novel composite wick structure

Experimental Investigation on Ultra-Thin Vapor Chamber with Composite Wick for Electronics Thermal Management

Evaluation of capillary wetting performance of micro-nano hybrid structures for open microgrooves heat sink

Numerical exploration of optimal microgroove shape in loop-heat-pipe evaporator

Fabrication and capillary characterization of multi-scale micro-grooved wicks with sintered copper powder