Abstract:Ash aerosol and ash deposit formation during oxy-coal combustion were explored through experiments in a self-sustained 100kW rated down-fired oxy-fuel combustor. Inlet oxidant conditions consisted of 50% inlet oxygen with CO2 (hereafter denoted as OXY50 conditions). A Berner low pressure impactor (BLPI), a scanning mobility particle sizer (SMPS), and an aerodynamic particle sizer (APS) were used to obtain size segregated ash aerosol samples and to determine the particle size distributions (PSD). A novel surface temperature controlled ash deposition probe system that allowed inside and outside deposits to be separated was used to collect the ash deposits. The ash aerosol PSDs given by the BLPI and those produced by SMPS/APS were consistent with each other. Data suggested that oxy-coal combustion under these conditions did not change the formation mechanisms controlling the bulk ash aerosol composition, but it did increase the formation of ultra-fine particles initially formed through metal vaporization, due to increased vaporization of silicon at the higher combustion temperature. The smaller particles contained within the deposits had higher Si and lower Na and S concentrations under OXY50 conditions than for air combustion. Moreover, the ash aerosol composition for particle sizes less than 2.4μm was related to the composition of the inside deposits. A higher Na in the ash aerosol resulted in higher Na in inside deposits with comparable absolute Na concentrations in both those aerosol particles and those inside deposits particles. The contribution of S and Si to the inside deposits showed that S in the vaporization modes together with Si in the ultrafine vaporization mode, contributed significantly to the composition of the inside deposits. These results provided direct evidence that prediction of the chemistry of the initial deposit layer (but not of the bulk deposits) required knowledge of the size segregated chemistry of the ash aerosol.

Numerical Investigation on Deposition Rate of Mechanically Mixed Ash Particles in an Entrained Flow Reactor

Modelling of initial deposition of biomass ash particles on walls of superheater tubes

Analysis of Formation and Growth Process of Ash Deposition on the Convective Heating Surface of a 400t/d MSW Incinerator Based on Different Operating Days

Integrated Gas and Solid Model to Determine the Flow Performance in the SCR Reactor

Ash Aerosol Formation from Oxy-Coal Combustion and Its Relation to Ash Deposit Chemistry

Simulation of Ash Deposition in Different Furnace Temperature with a 2D Dynamic Mesh Model

Numerical simulation and mathematical models of ash deposition behavior considering particle properties and operating conditions

Numerical simulation of solidification of boiler molten ash impinging on vertical wall based on Smoothed Particle Hydrodynamics method

CFD modelling of biomass ash deposition under multiple operation conditions using a 2D mass-conserving dynamic mesh approach

Dynamic evaluation of ash deposition behavior and parametric study using an inverse distance weighted interpolation dynamic mesh method

Numerical Simulation of Fluidized Bed Coating Process Considering Particle Abrasion

Numerical simulation on the deposition characteristics of MSWI fly ash particles in a cyclone furnace

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis

Kinetic Simulation Of Fine Particulate Matter Evolution And Deposition In A 25 Kw Pulverized Coal Combustor

Investigation of the Deposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Using an On-Line Digital Image Technique: Effect of Deposition Surface Temperature

Dynamic CFD modeling and evaluation of ash deposition behaviors during Zhundong coal combustion

An Experimental Investigation into the Characteristics and Deposition Mechanism of High-Viscosity Coal Ash

A Numerical Simulation Study into the Effect of Longitudinal and Transverse Pitch on Deposition of Zhundong Coal Ash on Tube Bundles

Numerical investigation of particle size distribution, particle transport and deposition in a modified chemical vapor deposition process

Experimental Study of the Influence of Temperatures under SCR Conditions Using an On-Line Digital Image Technique

Modeling on circulating fluidized bed flue gas desulfurization