Abstract:When the grain size is below a critical value, the deformation mechanism of nanocrystalline (NC) metal shifts from dislocation- to grain boundaries (GBs)-mediated activities. However, GB activities including deformation and rotation in the elastic and plastic stages have not given detailed analysis because of the limitation of current experimental techniques, as well as the unrealistic model with regular boundaries in most molecular dynamics (MD) simulation reducing the activities. To quantitatively analyze GB activities, we recently developed an algorithm based on moving least-squares interpolant. Besides, the phase field model was used to build the nanocrystalline (NC) Cu with more natural GBs for MD tensile simulation. The results of temperature dependence of Young's modulus (E), strain rate sensitivity (SRS), and variation of stress at GBs (σGB) and at grain interiors (σGI) are in good agreement with previous researches. In the elastic stage, the σGB fluctuates in a larger range than σGI. The vibrated σGB is the results of micro-elastic and micro-plastic deformation of GBs and the increased stage of σGB in one cycle can lead to increasing the σGI. Thus, the temperature dependence of E is affected by the frequency of vibrated σGB at relative low temperatures (T ≤ 450 K). The E is strain rate independent because of the same vibration of σGB. In the plastic stage, the flow stress strongly depends on the size of twinning boundaries (TBs) structures. The fraction of GB activities improves with increasing temperature and decreasing strain rate. GB activities can attenuate stress concentration on boundaries and then results in the formation and growth mechanism of TB changing from Shockley partial dislocation gliding on adjacent plane of stacking faults (SFs) to GB deformation. Thus, the size of TB at low temperatures and high strain rate is larger than that at the opposite conditions.

Effect of Grain Boundary Precipitation on Elastic Properties of Cu-2.0%Be Alloy

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Influence of Grain Orientation and Grain Boundary Features on Local Stress State of Cu-8Al-11Mn Alloy Investigated Using Crystal Plasticity Finite Element Method

The influence of precipitation transformation on Young's modulus and strengthening mechanism of a Cu–Be binary alloy

Interface Structure Between Ag Precipitates and Cu Matrix and Its Effect on the Properties of the Cu-Ag Alloy

Arrangement and Decomposition of Grain Boundary Dislocations: Two-Mode Phase-Field Crystal Simulation

The dependence of precipitate morphology on the grain boundary types in an aged Al–Cu binary alloy

The W alloying effect on thermal stability and hardening of nanostructured Cu-W alloyed thin films

Mechanical Properties and Fracture Behavior of Cu-Co-Be Alloy after Plastic Deformation and Heat Treatment

Evolution and strengthening mechanism of metastable precipitates in Cu-2.0 wt% Be alloy

Deformation Behavior of Cu-3.8Be Alloy Under Isothermal Compression Conditions

Discontinuous Precipitation Initiated At Interphase Boundaries In A Zn-Rich Zn-6.3 At.% Ag Alloy

Grain boundary evolution and effect on electrical conductivity of Cu Ti alloys prepared by accumulative roll bonding-diffusion alloying process

Influence of grain boundary activites on elastic and plastic deformation of nanocrystalline Cu as studied by phase filed and atomistic simulaiton

B2-precipitation induced optimization of grain boundary character distribution in an Al0.3CoCrFeNi high-entropy alloy

Molecular Dynamics Study on the Impact of Cu Clusters at the BCC-Fe Grain Boundary on the Tensile Properties of Crystal

Effect of grain boundary deformation on mechanical properties in nanocrystalline Cu film investigated by using phase field and molecular dynamics simulation methods

Atomic-scale study of compositional and structural evolution of early-stage grain boundary precipitation in Al–Cu alloys through phase-field crystal simulation

The Influence of Grain Boundaries on Crystal Structure and Tensile Mechanical Properties of Al0.1CoCrFeNi High-Entropy Alloys Studied by Molecular Dynamics Method

The effects of discontinuous precipitation and ordering on the age-hardening in Au-20Ag-30Cu (wt.%) alloy

Segregation assisted grain boundary precipitation in a model Al-Zn-Mg-Cu alloy