Improvement to the Calculating Model of the Pressure Arch’s Height Considering the Confining Pressure in the Excavation of Shallow Tunnels

Fan Hongyun,Li Liping,Liu Hongliang,Hu Jie,Zhang Mingguang,Zhou Shen,Yang Guangyu
DOI: https://doi.org/10.1007/s12517-021-07507-3
2021-01-01
Arabian Journal of Geosciences
Abstract:Based on Platts theory of ground pressure, the traditional formation stress distribution method was improved, and a stress model was constructed by the ring distribution. Then, the equilibrium equation of force was obtained considering the confining pressure. Based on that, the relationship between the limit equilibrium height of the pressure arch and the parameters of the tunnel was revealed. Then, the calculation model of the limit equilibrium height of the pressure arch was established considering the circumferential action of the rock mass in the shallow-buried tunnels. Via the finite differential method, a three-dimensional calculation model of the shallow-buried tunnels under V-level surrounding rock geological conditions was established, and tunnel excavation was simulated. Based on the results of the numerical simulation, the relation curve between the maximum principal stress and the tunnel depth was obtained, and then the limit equilibrium height of the pressure arch was determined. In addition, the error between the numerical simulation results and the theoretical calculation results was analyzed to verify the accuracy of the calculation formula, which proved the accuracy of the calculating model. Finally, the calculation model was applied to calculate the limit equilibrium height of the pressure arch of the Qianyu tunnel, which is an important section of the Lunan Highway in Shandong Province. According to the results, we found that the burial depth of the Qianyu tunnel was less than the minimum burial depth of the forming pressure arch, which was the essential reason for the collapse and surface subsidence during tunnel excavation. Therefore, the improved calculation model of the pressure arch height can be further used to calculate the limit equilibrium height of the pressure arch in shallow-buried tunnels.
What problem does this paper attempt to address?