Abstract:Powder compaction and sintering are critical stages of powder metallurgy in manufacturing high performance particle reinforced metal matrix composites. In this paper, particulate scale numerical investigations on the warm compaction and solid-state sintering of TiC/316L composite powders with different particle size ratios (PSRs, R316L/RTiC) and TiC contents were performed using multi-particle finite element method (MPFEM) in two dimensions. The effects of PSR and TiC content, compaction pressure and temperature, and sintering temperature on the compaction and sintering processes were comprehensively analyzed. On this basis, a variety of macro- and microscopic analyses were conducted to further identify the densification dynamics and mechanisms. The results indicate that green compacts with higher relative density and more uniform stress distribution can be readily achieved by warm compaction. The large-scale plastic deformation of 316L particles caused by the cooperative actions of temperature and pressure is the main densification mechanism in warm compaction. During solid-state sintering, the improvement of relative density is mainly achieved by the vanishing or shrinkage of residual pores along with the growth of sintering necks, accompanied by the deformation of 316L particles. Large displacements of particles mainly occur in contacting areas of adjacent particles. Moreover, the equivalent stress in 316L particles is smaller than that in TiC particles. With the increase of PSR and TiC content, lower relative density of green compacts and sintered parts were obtained and more irregular morphologies of 316L particles can be observed.

Investigation of the Experiment and Simulation on TiH2 Powder Packing by a Novel Irregular 3D Model

Preparation, Characterization and Designing of Porous Ti–6Al–4V Through Metal Injection Molding Without Space Holder

Simulation of 3D Volume Filling with Non-Spherical and Spherical Titanium Alloy Powder Particles for Additive Manufacturing

Establishment of constitutive models and numerical simulation of dry pressing and solid state sintering processes of MgTiO3 ceramic

Numerical study on the warm compaction and solid-state sintering of TiC/316L composite powders from particulate scale

Microstructure evolution and densification behavior of TiC/316L composite powders during cold/warm die compaction and solid-state sintering: 3D particulate scale numerical modelling and experimental validation

Packing of Cylindrical Particles: DEM Simulations and Experimental Measurements

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Effect of particle morphology on the flowability of HDH Ti powders treated by high temperature ball milling

Formation and evolution mechanisms of micropores in powder metallurgy Ti alloys

Shape Modification of HDH Ti Powder and Its Mechanism Analysis

Investigating phase transformation, densification and diffusion mechanism of TiH 2 powder to achieve a high ductile Ti6Al4V alloy

Experimental and Numerical Investigation of Densification Behaviors During Powder Compaction

Three-dimensional particle size, shape, and internal porosity characterization: Application to five similar titanium alloy (Ti–6Al–4V) powders and comparison to two-dimensional measurements

Finite Element Analysis of Densification Process in High Velocity Compaction of Iron-Based Powder

Optimization of structures and mass transformation in TiB2-Cu FGM fabricated by SHS

Binder Jetting Additive Manufacturing: Effect of Particle Size Distribution on Density

Densification behavior, mechanical and electrical properties of in-situ TiB 2p /Cu composite powder via vacuum hot pressing

Novel Composite Powders with Uniform Tib2 Nano-Particle Distribution for 3d Printing

Quantitative Analysis of the Physical Properties of Ti6Al4V Powders Used in a Powder Bed Fusion Based on 3D X-ray Computed Tomography Images