Abstract:Future actively cooled space-borne observatories for the far-infrared, loosely defined as a 1--10 THz band, can potentially reach a sensitivity limited only by background radiation from the Universe. This will result in an increase in observing speed of many orders of magnitude. A spectroscopic instrument on such an observatory requires large arrays of detectors with a sensitivity expressed as a noise equivalent power NEP = 3 $\times 10^{-20}$ $W\surd{Hz}$. We present the design, fabrication, and characterisation of microwave kinetic inductance detectors (MKIDs) for this frequency range reaching the required sensitivity. The devices are based on thin-film NbTiN resonators which use lens-antenna coupling to a submicron-width aluminium transmission line at the shorted end of the resonator where the radiation is absorbed. We optimised the MKID geometry for a low NEP by using a small aluminium volume of $\approx$ 1$\mu m^3$ and fabricating the aluminium section on a very thin (100 nm) SiN membrane. Both methods of optimisation also reduce the effect of excess noise by increasing the responsivity of the device, which is further increased by reducing the parasitic geometrical inductance of the resonator. We measure the sensitivity of eight MKIDs with respect to the power absorbed in the detector using a thermal calibration source filtered in a narrow band around 1.55 THz. We obtain a NEP$_{exp}(P_{abs})\:=\:3.1\pm0.9\times10^{-20}\:W\surd{Hz}$ at a modulation frequency of 200 Hz averaged over all measured MKIDs. The NEP is limited by quasiparticle trapping. The measured sensitivity is sufficient for spectroscopic observations from future, actively cooled space-based observatories. Moreover, the presented device design and assembly can be adapted for frequencies up to $\approx$ 10 THz and can be readily implemented in kilopixel arrays.

Development and Characterization of a MKID Camera for the Nobeyama Radio Observatory 45m Telescope

Development of Broadband Planar Ortho-mode Transducer with MKID for LiteBIRD Satellite

Investigation of Single-Crystal Niobium for Microwave Kinetic Inductance Detectors

Development of an $$8\times 8$$ 8 × 8 CPW Microwave Kinetic Inductance Detector (MKID) Array at 0.35 THz

Development of Octave-Band Planar Orthomode Transducer with Kinetic Inductance Detector for Litebird

An 8×8 CPW MKIDs Developed at 0.35THz

Performance of Hybrid NbTiN-Al Microwave Kinetic Inductance Detectors as Direct Detectors for Sub-millimeter Astronomy

Multiplexed Readout for 1000-pixel Arrays of Microwave Kinetic Inductance Detectors

The Thirty Millimeter Telescope

Current status and future plan of Osaka Prefecture University 1.85-m mm-submm telescope project

Development of an MKID frequency-to-pixel LED mapper for SPT-3G+

A readout for large arrays of Microwave Kinetic Inductance Detectors

Large-format platinum silicide microwave kinetic inductance detectors for optical to near-IR astronomy

Development of Thermal Kinetic Inductance Detectors suitable for X-ray spectroscopy

Ultra-sensitive Super-THz Microwave Kinetic Inductance Detectors for future space telescopes

Characterization of two-level system noise for microwave kinetic inductance detector comprising niobium film on silicon substrate

On-The-Fly Observing System of the Nobeyama 45-m and ASTE 10-m Telescopes

Kinetic inductance detectors for millimeter and submillimeter astronomy / Détecteurs à inductance cinétique pour l'astronomie millimétrique et sub-millimétrique

Configuration of Probe Tones for MKID Readout with Frequency Sweeping Scheme

Development of Microwave Kinetic Inductance Detectors for a THz On-Chip Spectrometer

Characterization of MKIDs for CMB observation at 220 GHz with the South Pole Telescope