Theoretical and Experimental Studies on Assessment of Bridges Using Simple Dynamic Procedures
Jianchun Li,Bijan Samali,Keith Crews,FC Choi,R Shestha
2005-01-01
Abstract:The ability to reliably determine the structural integrity of timber bridges is currently a challenge facing structural engineers. In Australia, Local Government is responsible for the operational management and maintenance of over 20,000 bridges. More than 70% of these bridges comprise aging timber bridges, the load capacity and structural adequacy of many of which have been impaired over time. A major challenge facing Local Government nationally is to develop effective strategies for the maintenance and rehabilitation of the extensive timber bridge stocks which form a key component of the road network under its control. Raising the efficiency and reliability of bridge maintenance practices of local government has the potential not only to minimise costly unscheduled emergency repairs, but also to reduce the overall maintenance costs, whilst improving the operational effectiveness of its road network. Responding to the needs, through a series of research and development projects, a simple dynamic testing method, based on the Structural Frequency Shift (SFS), was developed by authors (Benitez and Li (2002), Samali et al (2003a), Samali et al (2003b)) to lower the cost and shorten the testing time. The method has recently been successfully used to undertake field-testing of more than 60 timber bridges across NSW. The testing procedure involves the attachment of accelerometers underneath the bridge girders and exciting the bridge with a modal hammer with and without extra mass blocks at mid-span of the bridge. In order to refine the method and to further reduce cost and testing time as well as evaluate some of the practical issues during the field testing, a project has been initiated to investigate the effects of using alternative mass forms, such as use of a trailer to replace currently used mass blocks, and adding mass at locations other than mid-span, on the bridge vibrations and subsequent integrity assessment. In this paper, and after reviewing the SFS method, analytical and experimental investigations have been carried out to address the above-mentioned issues. The equivalent modal masses have been derived and used to normalise the analytically derived formula for other than mid-span mass locations. A beam with attached spring and masses was used to model the alternative mass, such as a trailer, for bridge testing. Experimental verifications have confirmed a good agreement with the analytical/numerical results.