Effects of Inorganic Nanofibers and High Char Yield Fillers on Char Layer Structure and Ablation Resistance of Ethylene Propylene Diene Monomer Composites

Jiang Li,Bowen Hu,Kun Hui,Kang Li,Li Wang
DOI: https://doi.org/10.1016/j.compositesa.2021.106633
IF: 9.463
2021-01-01
Composites Part A Applied Science and Manufacturing
Abstract:Influences of fillers [including multi-walled carbon nanotubes (MWCNTs), SiC nanowires, methyl-polyhedral oligomeric silsesquioxanes (methyl-POSS) and boron phenolic resin] on the characteristics of porous structure in char layers of ethylene propylene diene monomer (EPDM) composites were studied using experimental solid rocket motor (SRM). Comparing to basic formulation (Porosity: 78.25%), char layers of fillers formulation present lower porosity (Ranging from 64.03% to 67.69%) and showed significant trends of overall or local densification. Further analysis revealed different densification mechanisms: CNTs and SiC nanowires can promote chemical vapor deposition (CVD) reaction in char layers and reduce its porosity, which can be referred as "CVD-promotion densification"; boron phenolic resin is relatively high in char yield and char residue would densify the microstructure of char layers, which can be referred as "char residue densification"; methyl-POSS show a combination of both mechanisms, which lead to the lowest mass ablation rate [170.4 g/(m2.s)] and the best ablation performance.
What problem does this paper attempt to address?