Abstract:This study presents an experimental investigation on the internal flow of a ventilated supercavity using fog flow visualization and particle image velocimetry (PIV) measurements. The ventilated supercavity is generated on a backward-facing cavitator and studied in the high-speed water tunnel at St. Anthony Falls Laboratory. Fog particles are introduced into the supercavity through the ventilation line, and then illuminated by a laser sheet for flow visualizations and PIV measurements. The experiments are performed on the supercavities with two closure types, i.e. the re-entrant jet (RJ) and the twin vortex (TV), under the same water tunnel flow condition but different ventilation rates. The flow visualization revealed three distinct regions within the supercavity, including the ventilation influence region near the cavitator, the extended internal boundary layer along the liquid-gas interface and the reverse flow region occupying a large centre portion of the supercavity. The streamwise and vertical extent of the ventilation influence region, the streamwise growth of the internal boundary layer and the reverse flow within the supercavity are then quantified through PIV flow measurements. Compared to the RJ case, the results indicate that the TV supercavity yields a longer vertical extent of the ventilation influence region, a thinner internal boundary layer and a stronger reverse flow. The internal flow results suggest that at the upstream of the location of the maximum cavity diameter, the gas enters the forward flow (including the internal boundary layer and the forward moving portion of the ventilation influence region) from the reverse flow, while at the downstream of that location, the gas is stripped from the internal boundary layer and enters the reverse flow due to the increasing adverse pressure gradient in the streamwise direction. The above results are combined with visualization results of the supercavity geometry and closure patterns to further explain the influence of gas leakage mechanisms on cavity growth and closure transition. Specifically, visualization of the cavity geometry change during the RJ to TV supercavity transition indicates external flow separation associated with a critical incline angle of the bottom liquid-gas interface at the closure contributes to the onset of RJ closure. The closure visualization shows the coexistence of the toroidal vortex and twin-vortex tubes for the RJ supercavity leads to two gas leakage mechanisms: one associated with the shedding of toroidal vortices (Q(RJ)) and the other due to the gas entrained by the internal boundary layer and leaking from the twin-vortex tubes (Q(TV)). For the RJ supercavity, with increasing ventilation input, due to the reduction of Q(RJ), the supercavity needs to elongate to increase the gas entrained by the internal boundary layer (i.e. Q(TV)) to balance the ventilation increase. The elongation of the supercavity leads to reduced flow separation, and eventually a transition to the TV supercavity with ventilation above a critical value. For the TV supercavity, Q(RJ) is absent. An increase of ventilation input can be balanced by the increase of Q(RJ) associated with the widening of the twin-vortex tubes, and therefore, no appreciable elongation of cavity length is observed.

INVESTIGATION OF INTERNAL FLOW VELOCITY DISTRIBUTION AND GAS LOSS OF HIGH-SPEED SUPERCAVITATING FLOWS

Gas Flows and Losses Inside High-Speed Ventilated Supercavitating Flows

Numerical Investigation of Supercavity Geometry and Gas Leakage Behavior for the Ventilated Supercavities with the Twin-Vortex and the Re-Entrant Jet Modes

Multiphase Flow Characteristics and Gas Loss in the Shear Layer on a Ventilated Supercavity Wall

Comparison of Supercavity Geometry and Gas Leakage Behavior Between the Double-Cavity Flow Pattern and the Wake-Closure Flow Pattern

Experimental and numerical analysis of the physical characteristics of natural and ventilated supercavitating flows

Variation Characteristics of Formation and Development of Ventilated Supercavity at Low Froude Numbers

Experimental Study on Influence of Ventilation on Trajectory Characteristics of Free Motion of Supercavitating Vehicle

Experimental and Numerical Investigation of Ventilated Cavitating Flow Structures with Special Emphasis on Vortex Shedding Dynamics

Shear layer on a ventilated supercavity wall

A study on the wake structure of the double vortex tubes in a ventilated supercavity

On the Gas Leakage Way of Supercavity and Vehicle Vibration

Experimental Investigation on the Cavity Evolution and Dynamics with Special Emphasis on the Development Stage of Ventilated Partial Cavitating Flow

Analysis of the Effect of Underwater Supersonic Gas Jet on the Ventilated Supercavitation Flow

The effect of ventilation on supercavity around a supercavitating vehicle during water-entry

On the internal flow of a ventilated supercavity

Re-entrant Gas Flows of High-speed Ventilated Supercavity

On Inner Ventilation Flow Field of Supercavitating Vehicle

On the Nonlinear Hydrodynamic Characteristic of a Ventilated Supercavitating Vehicle with High Froude Number

Study on the interaction between ventilated cavitating flow and exhausted gas of an underwater vehicle

Numerical Investigation on the Ventilated Supercavity Around a Body under Free Surface Effect