Abstract:This paper presents a bridged contactless measurement technique that can measure the resonant frequency and quality factor of a fully-integrated powered off voltage-controlled oscillator (VCO). Unlike the use of the conventional two-coil inductive link, the proposed technique uses an additional inductor to bridge the coupling between the LC tank and the external inductor serving measurement purposes. This makes it possible to examine the on-chip high frequency oscillator with an off-chip inductor at Printed Circuit Board (PCB) level. As an example, a K-band VCO as well as the proposed test structure have been designed and simulated using 0.13 μm CMOS technology. The quality factor and operating frequency of the oscillator are measured using the proposed contactless technique through extraction from the frequency response of a bridged inductive link. The efficiency of the method has been validated by full wave electromagnetic simulation. As a reference, the characterization of the oscillator is also obtained using the Cadence Spectre RF and Mentor Graphic's Calibre PEX commercial Electronic Design Automation (EDA) software. The results of these two solutions agree considerably well, which supports the feasibility and potentials of using this technique for contactless measurements.

Widely Tunable Inductors Utilizing Transmission-Line With Variable Distributed Load Capacitor For Millimeter-Wave Applications

Differential VCO design with a wide frequency tuning range

Optimization of Injection Locked Frequency Divider with Tunable Active Inductor

A Ku-Band 20.4% Tuning Range VCO with a Tunable Harmonic-Resonant Transformer in 55 Nm CMOS

A Wideband Voltage-Controlled Oscillator with Gain Linearized Varactor Bank

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

A 20–25.5 GHz VCO Using a New Variable Inductor for K Band Application

An Improved Low Phase Noise LC-VCO with Wide Frequency Tuning Range Used in CPPLL

A 25MHz–6.44GHz LC-VCO using a 5-port inductor for multi-band frequency generation

A 4.4-Ghz 193.2-Db FoM 8-Shaped-inductor Based LC-VCO Using Orthogonal-Coupled Triple-Coil Transformer

Design and Analysis of Wide Frequency-Tuning-Range CMOS 60 GHz VCO by Switching Inductor Loaded Transformer

An 0.04–10.32 nH Ultracompact Tunable Inductor Based on Flexible Magnetic Coupling Tuning Technique

A 12.3–18.5-Ghz Single-Core Oscillator Using a Dual-Mode Variable Inductor with a Tunable Self-Resonant Frequency Technique

A 6.5mW, wide band dual-path LC VCO design with mode switching technique in 130nm CMOS

Design of miniaturized short wave tunable bandpass filter with wide tuning range based on LTCC technology

A FoM of −191 Db, 4.4-Ghz LC-VCO Integrating an 8-Shaped Inductor with an Orthogonal-Coupled Tail-Filtering Inductor

Transformer-based Varactor-Less 96ghz–110ghz VCO and 89ghz–101ghz QVCO in 65nm CMOS

Design Of Rf Amplifier With Tunable Active Inductor

Designs of CMOS Multi-band Voltage Controlled Oscillator Using Active Inductors

An 110 GHz CMOS Colpitts VCO based on switched coupled-inductor

A Low Gain Variation <i>LC</i>-VCO With Mutual Inductive Tuning for <i>K</i><sub>VCO</sub> Linearity Compensation