Abstract:Abstract Background Osteotomes are bone cutting tools commonly reused in orthopedic surgical procedures. Despite undergoing rigorous cleaning, visual inspection, and sterilization procedures between every use, the condition of the cutting blade edge is commonly not qualitatively assessed. Subjective feedback from surgeons suggests a large variation in osteotome cutting-edge sharpness is found during use. This study seeks to investigate the retention of osteotome cutting-edge sharpness by comparing the wear resistance of as-supplied, electroless nickel, and titanium nitride coated osteotomes following a series of bone cutting tests. Methods Changes in edge sharpness were assessed using visual inspection, depth penetration testing that quantified change in the blade sharpness index, and scanning electron microscopy visual analysis. Visual inspection of each osteotome blade edge was then compared to qualitative blade sharpness index measurement. Results After use, no cutting-edge damage or change in blade sharpness was detected by visual examination of all three osteotomes; however, the as-supplied osteotome demonstrated 50% loss of blade sharpness index compared to 30% and 15% reduction for the electroless nickel and titanium nitride coated osteotomes, respectively. This finding was supported by scanning electron microscopy evaluation that found greater mechanical damage had occurred along the cutting edge of the as-supplied osteotome compared to the two coated with wear resistant materials. Conclusions The rapid loss of blade sharpness found in the as-supplied osteotome supports the degradation in cutting performance frequently reported by surgeons. The findings from this study demonstrate blade sharpness index better detects cutting-edge wear compared to visual inspection. Results from this pilot study also suggest the coating of osteotomes in hard-wearing biocompatible materials assists in retaining cutting-edge sharpness over multiple uses. Further study using a larger sample size is required to validate these findings.

Failure behavior and influence of surgical tool edges in soft tissue cutting

Adhesion failure and anti-adhesion bionic structure optimization of surgical electrodes in soft tissue cutting

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

A quantitative model that correlates sharpness retention and abrasive wear of knife blades

A Comprehensive Understanding of Knife Cutting: Effects of Hardness, Blade Angle and the Micro-Geometry of Blade Edge on the Cutting Performance

Tissue Cutting Mechanics and Applications for Needle Core Biopsy and Guidance

Understanding The Deformation Of Metals In High Speed Cutting

Advances in machining of hard tissues – From material removal mechanisms to tooling solutions

Understanding the cutting mechanisms of composite structured soft tissues

Edge preparation methods for cutting tools: a review

Contributions in Medical Needle Technologies—geometry, Mechanics, Design, and Manufacturing

Cutting Force Of Hollow Needle Insertion In Soft Tissue

Pilot investigation into osteotome hard surface coating and cutting-edge degradation

Bionic design of tools in cutting: Reducing adhesion, abrasion or friction

Effect of cutting conditions on the serrated chip formation in high-speed cutting

Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining

Preparation and characterization of ultra-thin dicing blades with different bonding properties

Research on the cutting performance and contact behavior of a new bionic saw blade segment

Preparation of Cemented Carbide Insert Cutting Edge by Flexible Fiber-Assisted Shear Thickening Polishing Method

Numerical Investigation on the Effect of Cutting-Edge Shape Factor on the Cutting Performance of Titanium Alloy

Influence of Mechanical Factors on the Cutting Performance of an Ultrasonic Bone Scalpel