Abstract:Aiming to evaluate the serviceability performance of bridge piers after potential terrorist attacks or accidental explosions, the residual seismic performance of post-blast reinforced concrete (RC) piers was studied by performing the test and numerical simulation. Firstly, the field explosion and successive lateral cyclic loading tests were performed on two 1/2-scale RC piers, and a single lateral cyclic loading test was performed on two intact control piers for comparison. The test data such as the incident overpressure-time histories, as well as the damage profiles, hysteretic curves and skeleton curves of piers, etc. were obtained and fully discussed. Then, an integrated finite element (FE) analysis approach based on the explicit–implicit switching algorithm was proposed to reproduce the dynamic and quasi-static responses of RC piers under blast and successive lateral cyclic loadings. Furthermore, four commonly used concrete material models were systematically compared and evaluated based on the basic mechanical property, explosion, and lateral cyclic loading tests. Finally, by comparing with the test data, the applicability of concrete material models and corresponding parameters, as well as the proposed integrated FE analysis approach for the residual seismic performance analysis of post-blast RC piers were verified comprehensively. It is concluded that: (i) after 0.5 kg TNT explosion, the positive yield and peak forces obtained from the lateral cyclic loading test are close to those of the intact control piers, whereas the negative yield and peak forces decrease to 66 % and 70 % of the intact ones; (ii) after 1.0 kg TNT explosion, the positive yield and peak forces are 77 % and 81 % of the intact values, while the negative yield and peak forces are only 37 % and 42 % of the intact ones; (iii) by replacing the explicit algorithm with implicit algorithm during the residual seismic performance analysis, the computational cost is saved by about 70 times; (iv) Winfrith concrete model can better predict the residual seismic performance of post-blast RC piers, with the deviations limited in 20 %. The present work can provide a reference for the designer and researchers in evaluating the seismic performance of the post-blast RC bridge piers during the whole service life.

Nonlinear Failure Analysis of Bridge Pier Subjected to Vessel Impact Combined with Blast Loads

A Parametric Investigation on Ultra-low Cycle Fatigue Damage of Steel Bridge Piers under Horizontal Bi-directional Seismic Excitations

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Punching/Shear Strength of a Full-scale Tested Bridge Deck Slab

Shear Capacity of an Existing RC Bridge Deck Slab: FE Analysis Using Continuum Elements

A Multi-Level Structural Assessment Strategy for Analysis of RC Bridge Deck Slabs

Nonlinear numerical analysis and progressive damage assessment of a cable-stayed bridge pier subjected to ship collision

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Non-linear finite element modeling of damages in bridge piers subjected to lateral monotonic loading

Damage mechanism and assessment of precast double-column bridge piers under blast impact

Damage assessment of circular bridge pier incorporating high-strength steel reinforcement under near-fault ground motions

Experimental Tests and Numerical Simulations of Circular Reinforced Concrete Piers under Ship Impact

Field test and probabilistic vulnerability assessment of a reinforced concrete bridge pier subjected to blast loads

Numerical failure analysis of a continuous reinforced concrete bridge under strong earthquakes using multi-scale models

Reliability assessment and sensitivity analysis of vehicle impacted reinforced concrete circular bridge piers

Dynamic response performance of bridge piers under non-bottom vehicle collision

Experimental and numerical study on the residual seismic performance of post-blast RC piers

Experimental Testing and Numerical Simulations of Ship Impact on Axially Loaded Reinforced Concrete Piers

Seismic Analysis of Long Span Continuous Rigid-Frame Bridge with Thin-Walled High Piers

Study on time-varying seismic vulnerability and analysis of ECC-RC composite piers using high strength reinforcement bars in offshore environment

Dynamic response and performance of cable-stayed bridges under blast load: Effects of pylon geometry