Abstract:Load bearing conjunctions are never perfectly flat. They are covered by surface features, which may be either unintentional roughness inherent in the manufacturing process or a combination of such roughness with intentionally introduced surface texture. In either case, only a small proportion of load bearing surfaces are in contact and carry load. This depends on the surface topography, material properties and contacting conditions. Simple surface roughness characterisation parameters such as Ra, Rp etc. although commonly used do not give an adequate description, particularly where surfaces are deliberately textured. Furthermore Imaged surface topographies commonly exhibit features below the resolution of the imaging apparatus. We demonstrate the application of a fractal geometry analysis to honed internal combustion engine cylinder liners, imaged by Atomic Force Microscopy and Confocal Laser Scanning Microscopy. This method enables anisotropic surfaces to be characterised by five parameters which can then be used to generate model surfaces whose characteristics follow very closely those of the measured surface. Analysis of the structure function allows the determination of length scales and roughness features relevant at a given contact length. The reconstruction of anisotropic surfaces is demonstrated. Results from modelled contacts between these surfaces reveal the likely asperity contact geometry to be used in modelling contact and friction in these interfaces.

3d Fractal Dimension Measurement Of Smooth Engineering Surfaces

Characterization of Engineering Ceramics Ground Surface Based on Fractal Theory

Fractal characterization of mechanical surfaces

Study on the Correlation Between Fractal Evaluation of Roughness Cofeeicient and Sampling Interval

Fractal Characterization of Two Grinding Surfaces

Surface Roughness With Fractal

Research On The Fractal Of Surface Topography Of Grinding

Research into the Application of Fractal Geometry in Characterising Machined Surfaces

Fractal Characterization of Nano Anisotropic Rough Surface

A New Method for Calculating the Fractal Dimension of Surface Topography

Fractal characteristics of 3D surface topography in laser machining

SIMULATION AND CHARACTERIZATION OF FRACTAL ROUGH SURFACES

A Model for Fractal Dimension of Rough Surfaces

Approach to characterize rock fracture surface: Insight from its roughness and fractal dimension

Computation methods for fractal dimension of surface profile

Approach to Characterize Rock Fracture Surface: Insight from Roughness and Fractal Dimension

The characteristic fractal parameter for the characterization of rough surfaces

Fractal Characterisation of Inhomogeneous Rough Surfaces

Investigations on Relationship Between Fractal Dimension and 3-D Surfaces Topography of C.G. Irons under Dry Sliding

3D Fractal Investigation on Ultrasonic Vibration Assisted End Grinding Surface of Sicp/Al Composites

On Fractal Dimension of A Fracture Surface by Volume Covering Method