Abstract:It is difficult to control a surface wetting due to the random surface texture, but its fabrication is easy. Hence, the volume ratio is proposed through the 3D characterization of micro-structured surface in contrast to traditional roughness factor, fractal dimension and aspect ratio through 2D characterization. The objective is to investigate the wetting properties related to the characterization of irregularly microstructured surface. First, the irregularly micro-structured Si surfaces with 0.22-3.58 pin in depth were machined by the rubbing, the polishing and the grinding with different diamond abrasive grain size and random abrasive grain shape, respectively; secondly, the surface wetting properties were investigated with regard to the characterized parameters of measured micro-topographic surfaces; finally, the irregular wetting model was constructed by using volume ratio on the base of non-composite wetting. It is shown that the contact angle increases with increasing roughness factor and aspect ratio and decreasing fractal dimension on the irregularly micro-structured surfaces, but it is different from the prediction of non-composite wetting model. Moreover, the irregularly micro-structured surfaces without anisotropic properties produce smaller contact angles than regularly micro-structured surfaces with anisotropic properties. The experimental results show that an increase in volume ratio leads to a decrease in contact angle. It is identical to the predictions of the proposed model. This is because the volume ratio precisely illustrates 3D contact information between the liquid and solid interfaces. It is confirmed that the volume ratio may be utilized to predict and control the wetting of irregularly micro-structured surface. (C) 2015 Elsevier B.V. All rights reserved.

Investigations on Relationship Between Fractal Dimension and 3-D Surfaces Topography of C.G. Irons under Dry Sliding

Investigation on Topography of Dry Sliding Surface of Compacted Graphite Cast Iron

Characterization of Engineering Ceramics Ground Surface Based on Fractal Theory

3d Fractal Dimension Measurement Of Smooth Engineering Surfaces

3-D Topographical Characteristics of Dry Sliding Surface of Compacted Graphite Irons Coupled with Chromium Steel Disk

Study the Relationship of 3D Coating Morphology and Frictional Wear Based on Dual Surface Image

Correlation of Surface Fractal Dimension with Frictional Angle at Critical State of Sands

3D Fractal Analysis of Ultra Precision Grinding Influencing on the Surface Topography of Brittle Material

Investigation of Topographical Characteristics and Tribologic al Behavior of Compacted Graphite Iron in Sliding against 40Cr Steel under Different Dry Sliding Conditions

Characterization of Irregularly Micro-Structured Surfaces Related to Their Wetting Properties

In-situ Characterization of Three Dimensional Worn Surface under Sliding-Rolling Contact

Fractal Surface Of Sicp Metal Matrix Composites And Its Wear Resistance

Surface Topography Characterization in Steel Running-in Process of Dry Sliding Friction

Investigation on the Surface Morphology of Si3N4 Ceramics by a New Fractal Dimension Calculation Method

The Bi-Gaussian Theory to Understand Sliding Wear and Friction

Study on the variation of 3D topography of specific spot on sliding wear surface

The three-dimensional statistical characterization of plain grinding surfaces

Fractal characterization of mechanical surfaces

Research into the Application of Fractal Geometry in Characterising Machined Surfaces

Approach to characterize rock fracture surface: Insight from its roughness and fractal dimension

Analysis of the Fractal Structure of Rough Friction Surfaces to Establish Transient Regimes of Frictional Contact