Abstract:In the present study, the extensive efforts had been made to attain the higher-quality ZrCu based ribbons by optimizing the fabrication process. Under the same preparation conditions, the as-spun ZrCu based ribbons with the different amorphous state can be obtained by tailoring the chemical compositions. The microstructure of the as-spun Zr50Cu50 ribbon was featured with the amorphous matrix embedded with the B2 crystalline and the superior mechanical properties can be achieved as a result of the martensitic transformation induced by stress during deformation. The partial substitute of Cu by Ni and Co enhanced the ability of forming the amorphous Zr-Cu-Ni-Co ribbons and the size of the B2 crystalline gradually became smaller. The reduction of B2 crystalline in the amorphous matrix led to the slight decrease in the mechanical properties of the as-spun ZrCu based ribbons. However, the microstructure of the annealed ZrCu based ribbons was characterized by the nano-scale grain. Meanwhile, the nano-scale Cu10Zr7 precipitates distributed in the nanograin. The grain refinement and precipitation strengthening contributed to the superior mechanical properties of the annealed ZrCu based ribbons.

The Preparation And Properties Of Melt-Spun Cu60cr34zr2ti2co2 Contact Materials

Effects of Melt-Spinning on Refining of Microstructures for CuCr25 Alloy and Their Chopping Currents

Microstructures of Melt-Spun Cu100−x–Crx (x=3.4–25) Ribbons

Effect of Ni Addition on the Microstructures of Melt-Spun CuCr Ribbons

Effects Of Ti Addition On Microstructures Of Melt-Spun Cucr Ribbons

Preparation And Properties Of The Alloy Cucr25w1co1

The Microstructure and Mechanical Properties of the As-Spun and Annealed ZrCu Based Ribbons

Microstructure and Properties of CuCr Contact Materials with Different Cr Content

Preparation of CuCr25 Contact Materials by Vacuum Induction Melting

Effects of Zr addition on the liquid phase separation and the microstructures of Cu-Cr ribbons with 18-22 at.% Cr

Effect of titanium additives on the microstructure of melt-spun CuCr ribbons

Preparation of CuCr25 Alloys Through Vacuum Arc Smelting and Their Properties

Liquid and Solid Phase Separation During Melt Spinning and Annealing in Melt-Spun Cu–Cr Ribbons

Microstructure and Martensitic Transformation Behavior of the Ni50mn36in14 Melt-Spun Ribbons

Structure and Magnetic Properties of Melt-Spun Pr(Fe1-Xcox)(2) Alloys

Separation of Supersaturation Solid Solution and Effects on Resistivity in Melt-Spun Cu100-xCrx Ribbons

Thermal and arc erosion behavior of CuCr contact material based on large plastic deformation treatment

Effect of Cu Contents on Magnetic Properties of the Sm(Co0.74CuxFe0.1Zr0.04)8

Deformation Processed Cu-15 Wt Pct Cr Composite Synthesized by Hot Hydrostatic Extrusion of Mechanical Milled Powders

Microstructure and magnetic properties of melt-spun Sm(Co0.58Fe0.31Cu0.04Zr0.05B0.02)z ribbons

Processing and Properties of ZrB2-Cu Composites Sintered by Hot-Pressing Sintering