Effects Of Injection Timing Of Dme On Micro Flame Ignition (Mfi) Combustion In A Gasoline Engine

Y. Feng,T. Chen,H. Xie,X. Wang,H. Zhao
2020-01-01
Abstract:In order to achieve high dilution low temperature combustion and overcome the instability of spark ignition (SI)-controlled auto-ignition (CAI) hybrid combustion, the micro flame ignition (MFI) combustion technology was studied on a port fuel injection (PFI) gasoline engine. A small amount of Dimethyl Ether (DME) was directly injected into the cylinder to form multiple micro flame kernels, which initiated and formed the subsequent gasoline combustion process. The single cylinder engine results showed that the optimization of the MFI strategy increased the thermal efficiency from 33.65% to 42.87% at 2000 rpm and IMEP 4 bar. The NOx emission was reduced to nearly zero and the HC and CO emissions were 60% lower than the traditional SI or CAI/HCCI combustion. The in-cylinder mixture formation and combustion processes of the MFI technology was studied in a single cylinder optical engine by the particle image velocimetry (PIV), laser Rayleigh scattering, Mie scattering and high-speed imaging combined with heat release analysis. In addition to the optical measurements, three dimensional (3D) Computational Fluid Dynamics (CFD) simulations were performed to further explain the experimental observations. The results showed that the typical MFI hybrid combustion process is characterized by three distinct stages of DME auto-ignition followed by a flame propagation and then a final multi-point auto- ignition combustion process. As the DME injection timing was advanced, the MFI hybrid combustion process was shifted from a 2-stage heat release process to a single peak of heat release rate. The early injection of DME at the start of the compression stroke could improve overall reactivity of the fuel/air mixture in the cylinder and subsequent flame propagation process, and the late injection of DME near TDC acted as high- energy ignition kernels for enhanced ignition process of highly diluted mixtures.
What problem does this paper attempt to address?