Abstract:This paper reports the nonlinear dynamic modeling and the optimal trajectory planning for a flexure-based macro-micro manipulator, which is dedicated to the large-scale and high-speed tasks. In particular, a macro- micro manipulator composed of a servo motor, a rigid arm and a compliant microgripper is focused. Moreover, both flexure hinges and flexible beams are considered. By combining the pseudorigid-body-model method, the assumed mode method and the Lagrange equation, the overall dynamic model is derived. Then, the rigid-flexible-coupling characteristics are analyzed by numerical simulations. After that, the microscopic scale vibration excited by the large-scale motion is reduced through the trajectory planning approach. Especially, a fitness function regards the comprehensive excitation torque of the compliant microgripper is proposed. The reference curve and the interpolation curve using the quintic polynomial trajectories are adopted. Afterwards, an improved genetic algorithm is used to identify the optimal trajectory by minimizing the fitness function. Finally, the numerical simulations and experiments validate the feasibility and the effectiveness of the established dynamic model and the trajectory planning approach. The amplitude of the residual vibration reduces approximately 54.9%, and the settling time decreases 57.1%. Therefore, the operation efficiency and manipulation stability are significantly improved.

A Novel Macro/Micro Dual Driven Flexible Parallel Manipulator For Precision Positioning

Design and Control of a Piezoelectric Ceramic-actuated and Flexure Hinge-based Micromanipulator

Research on A Two-Dimension Micromanipulator Utilizing Flexure Hinges

A Novel Flexure-Based 3-DOF Micro-Parallel Manipulator with a Gripper for Micro/nano Manipulation

Conceptional Design and Kinematics Modeling of a Wide-Range Flexure Hinge-Based Parallel Manipulator

Research on a two-dimension micromanipulator with no displacement and little concentrated stress parasite

Realization of Two-Axis Macro-Micro Dual-Driven System

Large workspace flexure hinge-based parallel manipulator system

Integration modeling and control of a 12-degree-of-freedom macro-micro dual parallel manipulator

Design and testing of a high precision parallel manipulator with hyperbolic–elliptic flexure hinges

Analysis and Design of a Three-Limb Six Degree-of-Freedom Parallel Micromanipulator with Flexure Hinges

A Piezo-Actuated High-Precision Flexible Parallel Pointing Mechanism: Conceptual Design, Development, and Experiments

Design, modeling, analysis and testing of a novel piezo-actuated XY compliant mechanism for large workspace nano-positioning

Modeling and Prototype Experiment of A Six-Dof Parallel Micro-Manipulator with Nano-Scale Accuracy

Flexure Hinge and Its Application in Precision Parallel Manipulators

Structural Design and Experimental Evaluation of a Coarse-Fine Parallel Dual-Actuation XY Flexure Micropositioner with Low Interference Behavior

Nonlinear Dynamic Analysis and Optimal Trajectory Planning of a High-Speed Macro-Micro Manipulator

A Compliant Ultra-Precision 6-DOF Parallel Positioner Based on the Coarse/Fine Dual Architecture

A Calibration Method of Compliant Planar Parallel Manipulator

Long-Travel 3-PRR Parallel Platform Based on Biomimetic Variable-Diameter Helical Flexible Hinges

Modeling and Experimental Study of a Novel 3-RPR Parallel Micro-Manipulator