Abstract:To explore new approaches to severe plastic deformation and the ductility of a multicomponent magnesium-lithium alloy, an ultralight microduplex Mg-9.55Li-2.92Al-0.027Y-0.026Mn alloy was made by novel multidirectional forging and asymmetrical rolling, and the superplasticity behavior was investigated by optical microscope, hot tensile test, and modeling. The average grain size is 1.9 μm in this alloy after multidirectional forging and asymmetrical rolling. Remarkable grain refinement caused by such a forming, which turns the as-cast grain size of 144.68 μm into the as-rolled grain size of 1.9 μm, is achieved. The elongation to failure of 228.05% is obtained at 523 K and 1 × 10-2 s-1, which demonstrates the high strain rate quasi-superplasticity. The maximum elongation to failure of 287.12% was achieved in this alloy at 573 K and 5 × 10-4 s-1. It was found that strain-induced grain coarsening at 523 K is much weaker than the strain-induced grain coarsening at 573 K. Thus, the ductility of 228.05% is suitable for application in high strain rate superplastic forming. The stress exponent of 3 and the average activation energy for deformation of 50.06 kJ/mol indicate that the rate-controlling deformation mechanism is dislocation-glide controlled by pipe diffusion.

Superplasticity In Large-Grained Iron Aluminides

Superplastic behavior of large grained iron alluminides

On Phenomenon Of Superplasticity In Fe3al With Large Grains

Low temperature superplasticity in Fe3Al alloys

Study of Superplastic Deformation in an FeAl Based Alloy with Large Grains

The Phenomenon of Superplasticity in Feal-Ti Alloy with Large Grains

Introducing Equiaxed Grains and Texture into Ni-Mn-Ga Alloys by Hot Extrusion for Superplasticity

SUPERPLASTICITY IN LARGE-GRAINED Fe-36.5Al BASED ALLOYS ADDED Ti

Superplasticity In Fe3al Based Alloy

Superplastic Deformation of a Heat-Resistant Al–Cu–Mg–Ag–Mn Alloy

THE SUPERPLASTICITY OF Fe-28Al-5Cr AND Fe-28Al-5Cr-0.5Nb-0.1C ALLOYS

Superplastic Behavior of an Al–Mg–Li Alloy

Superplastic behavior of 1420Al-Li alloy

High Strain Rate Superplasticity in a Micro-grained Al{Mg{Sc Alloy with Predominant High Angle Grain Boundaries

In-situ surface study on the mechanism of high-strain-rate superplasticity in an Al–Cu–Li alloy

Superplasticity of a directionally solidified NiAl–Fe(Nb) alloy at high temperature

Achieving high strain rate superplasticity in an Al-Cu-Li alloy processed by thermo-mechanical processing

High Strain Rate Quasi-Superplasticity Behavior in an Ultralight Mg-9.55Li-2.92Al-0.027Y-0.026Mn Alloy Fabricated by Multidirectional Forging and Asymmetrical Rolling

Superplasticity of near-gamma TiAl alloys

Enhanced ductility in coarse grained Fe3Al alloys