Abstract:This study presents the design, implementation, and characterization of 1D resonant type micro-electro-mechanical-systems piezoelectric scanning mirrors with different actuator designs to investigate their influences on the figure of merits (FoM) for automotive LiDAR application. The MEMS scanning mirrors are driven by PZT thin film in this study owing to its outstanding piezoelectric properties. Three different beam-type piezoelectric actuators are designed, including the reference meander straight-beam actuator design, and the proposed meander curved-beam and straight-curved tapered beam actuator designs. Simulations show the scan angle enhancement for two proposed designs, yet the resonant scanning frequency of meander curved-beam design dropped to below the 2 kHz requirement. To evaluate the designs, scanning mirrors with two proposed actuators are fabricated and tested. Measurements show that the resonant frequencies for the two proposed MEMS scanning mirrors are 1735 Hz and 2578 Hz, respectively. Two proposed designs respectively have the maximum optical angles of 48.1° and 50.6° at the 20 Vpp driving voltage. Due to the much higher stress on the beam structure induced by the misalignment of PZT film, the actuator could not reach the predicted scanning angle of near 80°. In comparison of the two proposed designs, the straight-curved tapered beam actuator design could enhance the FoM for about 56%. In summary, the performances of piezoelectric MEMS scanning mirror can be improved by varying the designs of length and shape of actuator, and the distribution of PZT film on the suspended actuator is also a critical design concern.

Hysteresis Property of Tip-Tilt-Piston Micromirror Based on Tilt-And-Lateral Shift-Free Piezoelectric Unimorph Actuator

A new hysteresis modeling and optimization for piezoelectric actuators based on asymmetric Prandtl-Ishlinskii model

Modeling and Compensation for Dynamic Hysteresis of Piezoelectric Actuators Based on Lissajous Curve

Research on hysteresis of piezoelectric actuator

Hysteresis Compensation of Piezoelectric Deformable Mirror Based on Prandtl–Ishlinskii Model

Development Of A Low Capacitance Two-Axis Piezoelectric Tilting Mirror Used For Optical Assisted Micromanipulation

A Hysteresis Control Model of Piezoelectric Actuator Based on Microscopic Polarization Mechanisms

Hysteresis Characteristics and MPI Compensation of Two-Dimensional Piezoelectric Positioning Stage

Compensation of Hysteresis on Piezoelectric Actuators Based on Tripartite PI Model

A Hysteresis Compensation Method of Piezoelectric Actuator: Model, Identification and Control

Research on Asymmetric Hysteresis Modeling and Compensation of Piezoelectric Actuators with PMPI Model

A control model for hysteresis based on microscopic polarization mechanisms in piezoelectric actuator

Design of Butterfly Plate Piezoelectric Actuator with Dual Driving Electrodes for MEMS Micro-Mirror

Eliminating Hysteresis of Piezoelectric Deformable Mirror by Charge Control

Modeling and Compensating the Dynamic Hysteresis of Piezoelectric Actuators Via a Modified Rate-Dependent Prandtl–Ishlinskii Model

Feedback Controlled Pzt Micromirror with Integrated Buried Piezoresistors

PZT-Thick-Film Actuators Driven by Double Electrodes for MEMS Deformable Mirror

On the Design of Piezoelectric actuator for 1D MEMS scanning mirror applications

Intelligent Hysteresis Compensation and Tracking Control of Piezoelectric Fast Steering Mirror

Design and Fabrication of Non-Resonant PZT MEMS Micromirror with Buried Piezoresistors for Closed Loop Position Control

Study on the Hysteresis Property of Piezoelectric Actuator