Abstract:Establishing a material constitutive model reflecting the mechanical behavior of metal materials in the cutting process is the basis of cutting finite element simulation, and has an important guiding role in accurately describing the cutting thermo-mechanical coupling state variables and further optimizing process parameters. This paper proposes a reverse identification method of material constitutive parameters based on co-simulation. The influence of mass scaling factor, mesh size, and Johnson-Cook (J-C) constitutive parameters on cutting force was analyzed, and orthogonal cutting experiments were carried out for two difficult-to-machine materials, die steel H13 and titanium alloy Ti-6Al-4V. ABAQUS is redeveloped based on Python, and then the J-C constitutive parameters are directly optimized for the first time with the minimum error between the finite element simulation value and the experimental value of the cutting force as the objective function, the least square identification of J-C constitutive parameters based on co-simulation is realized by combining genetic algorithm. The results show that the reasonable setting of mass scaling factor and mesh size can significantly reduce the time of simulation calculation and improve the optimization efficiency of constitutive parameters. The yield stress, hardening coefficient, strain rate coefficient, hardening coefficient and softening coefficient of materials have different effects on cutting force, which is the key to effective inverse identification of constitutive parameters. Compared with different J-C parameters reported in the literature, it is found that the constitutive parameters obtained by inverse identification based on co-simulation are more accurate, and the prediction of residual stress and serrated chip characteristics also has good accuracy. This study provides a reference for the optimization of constitutive parameters, and the research results provide a new scheme for the efficient construction of material mechanical behavior required for cutting finite element simulation.

Determination of Constitutive Equation Parameters for Orthogonal Cutting Through Pressure Bar Tests and FEA Method

Determination of Constitutive Equation Parameters for Face Milling 3-D Simulation Via Pressure Bar and Orthogonal Cutting Tests

Identification of Material Constitutive Parameters Using Orthogonal Cutting Tests and Genetic Algorithm

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Study on Correlation Between Parameters of "single Factor" Constitutive Model and Temperature for 7050 Aviation Aluminum-Alloy

Inverse determination of improved constitutive equation for cutting titanium alloy Ti-6Al-4V based on finite element analysis

Coupled Thermo-mechanical Model for Metal Orthogonal Cutting Process and Finite Element Simulation

Inverse identification of material constitutive parameters based on co-simulation

A modified parallel-sided shear zone model for determining material constitutive law

New In Situ Imaging-Based Methodology to Identify the Material Constitutive Model Coefficients in Metal Cutting Process

Evaluation of constitutive models used in orthogonal cutting simulation based on coupled Eulerian–Lagrangian formulation

The development of FEM based model of orthogonal cutting for pure iron

Numerical Analysis and Punching Shear Fracture Based Design of Longitudinal Plate to Concrete-Filled CHS Connections

Parameter identification of Johnson-Cook constitutive model based on genetic algorithm and simulation analysis for 304 stainless steel

Inverse Identification of Constitutive Model for GH4198 Based on Genetic–Particle Swarm Algorithm

Finite Element Simulation of the Orthogonal Metal Cutting Process

An Hybrid Approach Based on Machining and Dynamic Tests Data for the Identification of Material Constitutive Equations

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

Identification of Dynamic Constitutive Parameters of a High-Strength Steel and Numerical Simulation

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

Inverse analysis procedure to determine flow stress and friction data for finite element modeling of machining