Abstract:The central element of a phased array antenna that performs beam electrical scanning, as well as signal transmission and reception, is the transceiver (T/R) module. Higher standards have been set for the integration, volume, power consumption, stability, and environmental adaptability of T/R modules due to the increased operating frequency of phased array antennas, the variability of application platforms, and the diversified development of system functions. Device-based multichannel T/R modules are the key to realizing low-profile Ka-band phased array antenna microsystem architecture. The design and implementation of a low-profile, high-performance, and highly integrated Ka-band phased array antenna T/R module are examined in this paper. Additionally, a dependable Ka-band four-channel T/R module based on Si/GaAs/Low Temperature Co-fired Ceramic (LTCC), applying multi-material heterogeneous integration architecture, is proposed and fabricated. The chip architecture, transceiver link, LTCC substrates, interconnect interface, and packaging are all taken into consideration when designing the T/R module. When compared to a standard phased array antenna, the module's profile shrunk from 40 mm to 8 mm, and its overall dimensions are only 10.8 mm × 10 mm × 3 mm. It weighs 1 g, and with the same specs, the single channel volume was reduced by 95%. The T/R module has an output power of ≥26 dBm for single-channel transmission, an efficiency of ≥25%, and a noise factor of ≤4.4 dB. When compared to T/R modules based on System-on-Chip (SOC) devices, the RF performance has significantly improved, as seen by an increase in single channel output power and a decrease in the receiving noise factor. This work lays a foundation for the devitalization and engineering application of T/R modules in highly reliable application scenarios.

A Ka Band Multi-Channel Integrated Receiver For Passive Millimeter Wave Imaging System

A Ka-Band 64-Element Four-Beam Phased Array Receiver with Inter-Beam Interference Cancellation

Ka Band Low Channel Mutual Coupling Integrated Packaged Phased Array Receiver Front-End for Passive Millimeter-Wave Imaging

A 144 GHz 2.5mW multi-stage regenerative receiver for mm-Wave imaging in 65nm CMOS

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

A Ka-Band Two-Channel Two-Beam Receiver Based on a Substrate-Integrated Suspended Line

Coupling Effects Analysis and Suppression in a Highly Integrated Ka-Band Receiver Front-End MMIC for a Passive Millimeter-Wave Imager System

A $K$ -Band Portable FMCW Radar with Beamforming Array for Short-Range Localization and Vital-Doppler Targets Discrimination

A Millimeter T/R Modules with High-Gain and High Power

A COMPACT X-BAND RECEIVER FRONT-END MODULE BASED ON LOW TEMPERATURE CO-FIRED CERAMIC TECHNOLOGY

A Fully Integrated K-Band Dual Down-Conversion Receiver for Radar Applications in 90 Nm CMOS.

Performance Evaluation of A Passive Millimeter-Wave Imager

A 90‐ to 115‐ghz Superheterodyne Receiver Front‐end for W‐band Imaging System in 28‐nm Complementary Metal‐oxide‐semiconductor

A 29-to-36 GHz 4TX/4RX Dual-stream Phased-array Joint Radar-Communication CMOS Transceiver Supporting Centimeter-level 2D Imaging and 64-QAM OTA Wireless Link

A Highly Linearized Ka-band Heterodyne Receiver using a Folded Class-AB Inductive Peaking Mixer and Magnetic-Self-Cancellation-Transformer-Based IF Amplifiers

All-Optical and Broadband Microwave Image-Reject Receiver Based on Phase Modulation and I/Q Balanced Detection

A Ka-Band 4TX/4RX Dual-Stream Joint Radar-Communication Phased-Array CMOS Transceiver

Design of A Pmmw Imaging System

Design of W-band Passive Millimeter Wave Imaging System

Design of a Ka-Band Heterogeneous Integrated T/R Module of Phased Array Antenna