Abstract:This paper presents a 27.7-31.2 GHz highly integrated 8-element 4-beam transmitter front end in 65-nm CMOS for phased-array applications. The proposed hybrid variable-gain amplifier (VGA) combines digital common-source (CS) VGA and analog Gilbert-cell-based VGA to realize a large tuning range and high resolution simultaneously. Furthermore, the proposed VGA scheme also integrates with an active combining network to implement a compact multi-beam structure. In the vector-modulation-based phase shifter (PS), low/high pass lumped delay lines are inserted between CS transistors and common-gate (CG) transistors to form I/Q signals which drive four pairs of Gilbert-cell based G(m)-arrays for different phase states. In addition, the output element leverages a symmetrical transformer-based Doherty power amplifier (PA) and an analog adaptive bias to improve the power-back-off (PBO) efficiency with a high peak-to-average-ratio (PAPR) modulation signal. With a 1.1-V supply voltage, this front end achieves a saturated output power (P-sat) of 19.2 dBm with a 20.5% channel efficiency and a 1-dB compression point (OP1dB) of 18.2 dBm. The measured maximum drain efficiency (DE) is 40.8% and 6-dB PBO DE is 28%. Compared with class-B/A PAs, the DE is improved by 40%/180%. The proposed hybrid VGA achieves a 27-dB tuning range and a 0.25-dB gain step with 0.26 dB/1.9 degrees RMS gain/phase errors. The active PS implements 6-bit 360 degrees phase shifting with 0.25 dB/2.5. RMS gain/phase errors.

A Modulation Depth and Output Power Tunable 5.8-Ghz Cmos Direct-Conversion Transmitter

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 2 GS/s 14-Bit Current-Steering DAC in 65 Nm CMOS Technology for Wireless Transmitter

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A CMOS Power Amplifier with 100% and 18% Modulation Depth for Mobile RFID Readers

Analog Front-end Circuit Design of Transmitter Used in ETC

A 1/2/4mhz Multi-Mode Reconfigurable Lowpass/complex Bandpass CT ΣΔ Modulator for Short Range Wireless Receiver

Digitally Equalized CMOS Transmitter Front-End with Integrated Power Amplifier

A 0.13µm CMOS 1.5-to-2.15ghz Low Power Transmitter Front-End for SDR Applications

A 130nm CMOS direct conversion transmitter for WCDMA

A Low Power Low Voltage 16 Bit Audio &#x03a3;&#x0394; Modulator

A 60 Ghz Low Power Direct-Conversion Quadrature-Phase Transmitter In 130 Nm Cmos With Low Profile Cavity Backed Antenna

Dual-mode 10mhz BW 4.8/6.3mw Reconfigurable Lowpass/complex Bandpass CT &#x03a3;&#x0394; Modulator with 65.8/74.2db DR for a Zero/low-if SDR Receiver

A Current-Mode 6&#x2013;9ghz UWB Transmitter with Output Power Flattening Technique

A Digital ΣΔ Modulated Class-S Transmitter with Two-Step Up-conversion and Filter-less Front End

Cmos Integrated Low Tx Noise Digital Transmitter with Tunable Directional Coupler for High Performance Uhf Rfid Reader

A Low Power Low Voltage 16 Bit Audio SigmaDelta Modulator.

CMOS Highly Linear Direct-Conversion Transmitter for WCDMA with Fine Gain Accuracy

A 20-32Ghz Digital Quadrature Transmitter with Notched-Matching and Mode-Switch Topology for 5G Wireless and Backhaul

A Fully CMOS Integrated Transmitter for Wireless LAN Applications