Abstract:Interactions between multiple flaws with different sizes in brittle solids are a key factor that induce failure. Previous studies have focused on the initiation, propagation and coalescence behaviors of multiple flaws in brittle solids. Nevertheless, there have been few theoretical or quantitative analyses of interactions between multiple flaws. In the present study, based on the Kachanov method, we first proposed theoretical analytical solutions of the stress intensity factors (SIFs) for two and three collinear flaws with unequal lengths under uniaxial tensile conditions. Then, a theoretical analysis of the effects of various geometric factors, such as flaw interval, flaw length and flaw number, was performed. The results supported the following findings: 1) For two collinear flaws, interactions between the primary and secondary flaws gradually weakened with increasing flaw interval, and the flaw length ratio gradually became the main factor that determined the interaction. 2) For three collinear flaws, when the interval between the primary and secondary flaws was not less than 1.5 times the length of the secondary flaw, the interaction had no effect on the propagation of the primary flaw. 3) The increase in the number of collinear flaws significantly enhanced the effect on propagation reinforcement between the flaws. Finally, numerical simulations were conducted to verify the results of the theoretical analysis, and good consistency was found. These research results are of great theoretical significance and engineering value for quantitatively understanding the failure mechanism of brittle solids containing multiple flaws and proposing effective measures to prevent cracking and ensure the safety of brittle solid structures.

Characterization of Interaction Between Elliptical Subsurface Flaws

Study on the Relationship Between Interaction Factors and Stress Intensity Factor for Elliptical Flaws

Evaluation of Stress Intensity Factor Interactions Between Adjacent Flaws with Large Aspect Ratios

Alternative Characterization Rules for Multiple Surface Planar Flaws

Micro Failure Analysis of Fiber Metal Laminates

Study on Flaw-to-Surface Proximity Rule for Transforming Subsurface Flaws to Surface Flaws Based on Fatigue Crack Growth Experiments

Proximity Factor on Transformation from Subsurface to Surface Flaw

INTRODUCTION OF SUBSURFACE PROXIMITY CRITERIA IN THE WORLD AND STRESS INTENSITY FACTORS FOR TRANSFORMED SURFACE FLAWS

Stress Intensity Factors for Transformed Surface Flaws and Remaining Fatigue Lives Based on Flaw-to-Surface Proximity Rules

Rules For Flaw Interaction For Subsurface Flaws In Operating Pressurized Vessels: Technical Basis Of Code Case N-877

Re-Characterization of Subsurface Flaw to Surface Flaw Based on Equivalent Fatigue Crack Growth Rate

Theoretical Analysis of Stress Intensity Factors and Interactions of Collinear Flaws with Unequal Lengths in Brittle Solids Under Uniaxial Tensile Conditions

Flaw-to-surface proximity rules and fatigue crack growth behavior for transformed surface flaws

Fatigue Crack Growth for Subsurface Flaws Near Component Surface and Proximity Rules

Interaction between rectangular cracks embedded in infinite medium

Development of Stress Intensity Factors for Subsurface Flaws in Plates Subjected to Polynomial Stress Distributions

Cracking Behavior and Acoustic Emission Characteristics of Rock Containing a Single Preexisting Flaw

Fatigue Lives of Multiple Flaws in Accordance with Combination Rule

Comparison of Experiment and Calculation on Fatigue Crack Growth for Transformed Surface Flaw

Fatigue Crack Growth Calculations for Vessels Considering Subsurface to Surface Flaw Proximity Rules

Interaction Factors for Two Elliptical Embedded Cracks with a Wide Range of Aspect Ratios