Abstract:This brief presents a wideband millimeter-wave (mm-Wave) low noise amplifier (LNA) with a triple-coupled technique for multiband wireless applications. To enlarge the gain and reduce the supply voltage, a modified cascode topology exploiting a triple-coupled transformer is developed. Thanks to the transformer, the transconductance of the common-gate (CG) transistor of the cascode topology is also effectively boosted, and hence the gain is further increased. Furthermore, high-order networks, which are realized by combinations of $pi $ - and T/L-type structures or transformers, are employed to implement the input, inter-stage, and output impedance matchings. They significantly broaden the bandwidth of the circuit. The LNA is demonstrated using a commercial 65-nm CMOS process. The measurement results show that the circuit achieves a maximum gain of 28.5 dB and a 3-dB gain bandwidth of 20 GHz with 32-mW dc power consumption ( $P_{dc}$ ). The measured noise figure (NF) and input 1-dB gain compression point ( $IP_{1dB}$ ) are 2.7~3.2 dB and −24.6~−20.4 dBm, respectively, over the entire operating bandwidth.

S-Band Low Power Consumption Amplifier For Rfid Applications

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

Ultra low power consumption HMIC amplifier for wireless applications at 2.45 GHz

A C‐band Ultra‐low‐power Consumption HMIC Amplifier for Intelligent Transportation System Applications

A dual band CMOS two-stage variable gain low noise amplifier

A Dc-13ghz Lna For Uwb Rfid Applications

A 21-to-41-GHz High-Gain Low Noise Amplifier With Triple-Coupled Technique for Multiband Wireless Applications

Design of a Low Power Current-Driven Passive Mixer

A K-Band High-Gain Lna In 0.13-Mu M Rf Cmos

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

High Quality of 0.18&#x03bc;m CMOS 5.2ghz Cascode LNA for RFID Tag Applications

A Low-Power 2.4-Ghz Receiver Front-End with a Complementary Series Feedback LNA and a Current-Reused Passive Down-Converter Based on Gm-Boosted TIA for WSN Applications.

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A Low Power Low Cost Fully Integrated Uhf Rfid Reader With 17.6dbm Output P1db In 0.18 Mu M Cmos Process

A g /I -Based Low-Power LNA for Ka-Band Applications

A Low-Power, Regulated Cascode, Low Noise Amplifier in 40nm CMOS for Millimeter-Wave Applications

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A 900 MHz,21 Dbm CMOS Linear Power Amplifier with 35% PAE for RFID Readers