Abstract:Here, we focus on induced degradation and spatial inhomogeneity of organic photovoltaic devices under different environmental conditions, uncoupled from the influence of a hole-transport (HT) layer. During testing of devices comprising the standard photoactive layer of P3HT as donor, blended with PCBM as acceptor, a comparison was made between the nonencapsulated devices upon exposure to dry air, dry air with illumination and humid air. The impact on the active layer's photophysics is discussed, along with the device physics in terms of integral solar cell performance and spatially resolved photocurrent distribution with point-to-point analysis of the diode characteristics to determine the origin of the observed behavior. The results show that even without the widely used hygroscopic HT layer, PEDOT:PSS, humidity is still a major factor in the short-term environmental degradation of organic solar cells with this architecture, and not only oxygen or light, as is often reported. Different from previous reports where water-induced device degradation was spatially homogeneous and formation of Al2O3 islands was only seen for oxygen permeation through pinholes in aluminum, we observed insulating islands merely after humidity exposure in the present study. Further, we demonstrated with laser beam induced current mapping and point-to-point diode analysis that the water-induced performance losses are a result of the exposed device area comprising regions with entirely unaltered high output and intact diode behavior and those with severe degradation showing detrimentally lowered output and voltage-independent charge blocking, which is essentially insulating behavior. It is suggested that this is caused by transport of water through pinholes to the organic/metal interface, where they form insulating oxide or hydroxide islands, while the organic active layer stays unharmed.

Bubble Formation Due to Electrical Stress in Organic Light Emitting Devices

Photoluminescence Degradation in Organic Light-Emitting Devices

Bubble Formation in Organic Light-Emitting Diodes

Study on the Degradation of PLEDs by In-Situ Micro-Raman Spectroscopy

Analyzing degradation effects of organic light-emitting diodes via transient optical and electrical measurements

Stressing Organic Light-Emitting Diode under Constant-Brightness Driving Mode

[Study on Electro-Degradation of New Conjugated Polymer PFO-BT15 Light Emitting Diodes].

Real-Time Observation Of Temperature Rise And Thermal Breakdown Processes In Organic Leds Using An Ir Imaging And Analysis System

Study on Lifetime of High Brightness Green Organic Light Emitting Devices

Short-Term Environmental Effects and Their Influence on Spatial Homogeneity of Organic Solar Cell Functionality

Short-Term Degradation Behaviors of Light Emitting Diodes Made of Polyurethane Derivative with Large Permanent Dipoles on the Side Chain

Anomalous Efficiency Elevation of Quantum-Dot Light-Emitting Diodes Induced by Operational Degradation.

Study on the Degradation of Polymer Light-Emitting Diodes by In-Situ Micro-Raman Spectroscopy

Photodegradation of Organic Light-Emitting Devices Observed in Nitrogen-Filled Environment

Degradation Mechanisms in Blue Organic Light-Emitting Diodes

Degradation characteristics and light-induced effects of polymer thin-film transistors

Decoupling Degradation in Exciton Formation and Recombination During Lifetime Testing of Organic Light-Emitting Devices

Deterioration of Li-doped phenanthroline-based charge generation layer for tandem organic light-emitting diodes

Observation of reversible light degradation in organic photovoltaics induced by long-persistent radicals

Degradation Behaviors of NPB Molecules upon Prolonged Exposure to Various Thermal Stresses under High Vacuum below 10-4 Pa

Joule Heating Effect and Organic Decomposition in Organic Light-Emitting Diodes