Abstract:Recent decades have seen a growing concern about ever-increasing green house gas (GHG) emissions and depletion of fossil fuels. Polygeneration, a multi-input multi-output energy system, provides huge opportunities to tackle these problems due to its superior performances over conventional energy systems in terms of energy conversion efficiency and GHG emissions. Many approaches have been made in process design and analysis of polygeneration energy systems, but most of them focus on using coal gasification as the only way to provide gas for downstream utilization. Coke oven gas, another gas source with huge capacity, however, has not received enough attention in polygeneration process design, and researches in this field are still rather limited. In this paper, we present a dual-gas sourced polygeneration process design which uses both gasification gas and coke oven gas and produces methanol, dimethyl ether (DME), and dimethyl carbonate (DMC) in an integrated catalysis procedure. Gasification gas and coke oven gas are converted to synthesis gas, or syngas, via a catalytic reforming procedure, where the ratio between carbon monoxide and hydrogen in the syngas is carefully adjusted according to specific requirements of downstream chemical synthesis reactions. An integrated catalysis procedure follows, where DME is synthesized from the fresh syngas first, unconverted syngas is then sent to a methanol synthesis unit to produce methanol, and part of the methanol is further converted to DMC in a DMC synthesis unit. Based on the proposed process design, an exergoeconomic analysis and an exergy cost distribution diagram are presented, from which the production cost of a product over each functional block of the process can be easily obtained. Analysis results show that the largest exergy loss occurs in an exothermic reformer, accounting 60.4 percent of the total exergy loss. The exergy cost distribution diagram indicates that DMC has the highest exergy cost, followed by DME and methanol, and it is economically favorable to use the exhaust gas from the chemical synthesis block for power generation.

Systematic Analysis and Design of the Poly-Production Process for Power and Olefin from Natural Gas

Strategy of Effluent Recovery Technology Selection in Polyolefin Plants

Energy and Exergy Analysis of Poly-Generation System of Hydrogen and Electricity Via Coal Partial Gasification

Techno-economic evaluation for coal-based polygeneration systems of heat, power, oil and synthetic natural gas

Design and Analysis of a New Dimethyl Ether- Electric Power Polygeneration System

Exergy analysis of a typical polygeneration system

A dual-gas sourced integrated methanol/DME/DMC catalysis approach to polygeneration energy systems design and an exergoeconomic analysis

A novel process design and techno-economic analysis for coal-based polygeneration process of synthetic natural gas, methanol and power

A conceptual hydrogen, heat and power polygeneration system based on biomass gasification, SOFC and waste heat recovery units: Energy, exergy, economic and emergy (4E) assessment

Exergy Analysis and Multi-Objective Optimisation for Energy System: a Case Study of a Separation Process in Ethylene Manufacturing

Olefin Production Via Methanol Integrated with Light Hydrocarbon Conversion: Novel Process Designs, Techno-Economic Analysis, and Environmental Analysis

Performance Assessment of a Novel Polygeneration System Based on the Integration of Waste Plasma Gasification, Tire Pyrolysis, Gas Turbine, Supercritical CO2 Cycle and Organic Rankine Cycle

Environmental and exergoeconomic analysis of a low-carbon polygeneration process based on biomass energy, a geothermal source and a high-temperature fuel cell

Emergy and life cycle assessment of polygeneration system

Exergy Analysis of Methanol-Igcc Polygeneration Technology Based on Coal Gasification

Experimental and Numerical Investigation of Pellet and Black Liquor Gasification for Polygeneration Plant

Process design and techno-economic analysis of the coproduction of oil, electricity, and protein from plastics and biomass using an integrated system

Techno-Economic Analysis of an Integrated Biorefinery System for Poly-Generation of Power, Heat, Pellet and Bioethanol

Advanced Exergy-Based Optimization of a Polygeneration System with CO2 as Working Fluid

Simulation and exergoeconomic analysis of a dual-gas sourced polygeneration process with integrated methanol/DME/DMC catalytic synthesis

Exergy Analysis of Coal-Based Series Polygeneration Systems for Methanol and Electricity Co-Production