Abstract:This article proposes a digital control structure for a doubly decoupled gyroscope working in the Lissajous frequency-modulated (LFM) mode based on digital phase-locked loops (PLLs), which demodulates the angular rate signal directly from the readable digital gyroscope resonance frequency, eliminating the need for specific frequency readout circuits. The resonance frequencies of the LFM gyroscope working modes contain a mode mismatch frequency modulated by input angular rate, respectively, which are tracked by two digital PLLs followed by subsequent digital demodulation and filtering. A linearized model of the digital PLL is built to analyze noise and control characteristics for different PI parameters. The impact of different amplitude–phase extraction architectures on the extracted phase signal is also addressed in this article. Contrast experiments are carried out using the same gyroscope with large internal thermal stress due to the silicon-glass bonding process and no stress relief structure around the sensing element, working in the traditional amplitude-modulated (AM) mode and the LFM mode. Overall, the LFM working mode maintains its low-temperature sensitivity and high stability in spite of the large internal thermal stress in the gyroscope compared to AM working modes. The maximum scale factor variation over the temperature range from 10 °C to 50 °C is 1000 ppm for the LFM mode compared to 51 900 ppm for the AM closed mode. The maximum zero rate output drift over the same temperature range is 0.1248 °/s for the LFM mode and 10.7139 °/s for the AM closed mode. The scale factor nonlinearity is 329 ppm with an angular rate input range of ±50 °/s for the LFM mode compared to 1902 ppm for the AM closed mode. The LFM mode zero-bias fluctuation for ten days is less than 0.12 °/s. The angle random walk (ARW) and the bias instability (BI) of the LFM gyroscope are 0.316 °/ $\surd \text{h}$ and 2 °/h, respectively.

A Low Noise Readout Circuit for a Novel Rotational Gyroscope Based on Phase Sensitive Detection

High Performance Interface Circuit for MEMS Gyroscope

A Digital Control Structure for Lissajous Frequency-Modulated Mode MEMS Gyroscope

Noise Analysis and Modeling for a Digital Control Architecture for Lissajous Frequency-Modulated MEMS Gyroscope with Amplitude-Modulated Readout

Performance Improvement for MEMS Gyroscopes by Suppressing the Circuit Phase Delay

A Low-Noise Readout Interface For Silicon Mems Vibratory Gyroscope

Low-Noise Low-Delay Digital Signal Processor for Resonant Micro Optic Gyro

The Signal Detection for the Levitated Rotor Micro Gyroscope

Digital Detection and Optimization Design for Resonant Fiber Optic Gyroscope

A novel demodulation scheme in the digital readout system for a micro-machined gyroscope

Short Fiber Resonant Optic Gyroscope Using the High-Frequency Pound-Drever-Hall Technique.

Resonant Fiber Optic Gyro Based on A Sinusoidal Wave Modulation and Square Wave Demodulation Technique

A Low Noise Bulk Micromachined Gyroscope With Symmetrical And Decoupled Structure

A Low-Noise HV Interface Circuit for MEMS Vibratory Gyroscope

Resonator Fiber Optic Gyroscope with an All Digitalized System

Micro-angle Tilt Detection for the Rotor of a Novel Rotational Gyroscope with a 0.47″ Resolution

Digital Readout System for Micromachined Gyroscope and Analysis for Its Demodulation Algorithm

Synchronous Digital Quadrature Demodulation Technique For Resonant Optic Gyroscopes

New low noise closed-loop driving circuit for the micro-gyroscope

A low-noise interface for MEMS vibration gyroscope based on a novel power-efficient C/V conversion structure

Design of a Digital Control System of Gyroscope