Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Design and Stiffness Analysis of a XYZ Scanning Stage

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

Design and Verification of an XYZ Three-axis Micro Stage

Design and Analysis of a New Flexure-Based XY Stage

A Novel Hybrid Actuation Mechanism Based XY Nanopositioning Stage with Totally Decoupled Kinematics

A piezodriven three dimensional micropositioning stage for nano-manufacturing

A Straight-Arch-straight Beam Tandem Quasi-Zero Stiffness Structure

Design, modeling, analysis and testing of a novel piezo-actuated XY compliant mechanism for large workspace nano-positioning

[A multicenter clinical trial of piperacillin/tazobactam in burn infection].

Modular Kinematics and Statics Modeling for Precision Positioning Stage

A Novel Piezoelectrically Actuated 2-Dof Compliant Micro/Nano-Positioning Stage with Multi-Level Amplification

Scanning near-field lithography with high precision flexure orientation stage control

Design, Control of an Aerostatic X-Y Planar Motion Stage for Precision Positioning

AN XY NANOPOSITIONER WITH A SELF-ADJUSTING STIFFNESS CENTER MODULE

A 2-DOF nano-positioning scanner with novel compound decoupling-guiding mechanism

Development of a compact and long range XYθ(z) nano-positioning stage.

Design of a compact long-stroke high-precision rigid-flexible coupling motion stage driven by linear motor

Analysis and design of spatial compliant mechanisms using a 3-D dynamic stiffness model

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

A Self-Adjusting Stiffness Center Design for Large Stroke Compliant XY Nanomanipulators

A Spatial Design of a Large Stroke Compliant XY Nanomanipulator with Cross-Coupling Error Reduction