Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Study On Fuzzy Clustering Approach In Analyzing Defects Of Cold Extruded Part (Id : 6-020)

Pattern Recognition of Dynamic Failure Mode of Grid Structure Using Fuzzy Clustering

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Study on Milling Deformation of Aerospace Frame Monolithic Components

Numerical Simulation and Analysis of Symmetry and Step-symmetry Milling of Aerospace Thin-walled Workpiece

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Analyzing Deformation of Auto-body Stamping with Fuzzy Clustering Approach

Research on applications of fuzzy ANN in cold extrusion process design

Reliability Evaluation of Precision Hot Extrusion Production Line Based on Fuzzy Analysis

A Kind of Generalized Fuzzy C-means Clustering Model and Its Applications in Mining Steel Strip Flatness Signal

Study on Warm and Cold Extrusion of Cup-shaped Part

Defect Analysis of Complex-Shape Aluminum Alloy Forging

Numerical simulation and experimental study on cold extrusion process for clutch outer gear hub with inner tooth shapes

Research on Selecting Approach of ANN Training Samples Based on Taguchi Method and Its Applications to Cold Extrusion Process Design

Research On Binary Feature Encoding Approach Of Ann And It'S Application To Cold Extrusion Process Design (Id : 8-129)

Thermal Error Modeling of Machine Tool Based on Fuzzy C -Means Cluster Analysis and Minimal-Resource Allocating Networks

Application of FCM clustering based rough sets on steel rolling process

Research on Applications of Soft Computing in Metal Forming

Simulation of Compound Cold Extrusion Al-Zn-Mg-Cu Alumium Alloys

Finite element analysis of residual stresses and thin plate distortion after face milling

Study and Application on Internal Quality Model Based on Intelligence Methods in Continuous Casting Billet