Abstract:Colloidal probe microscopy, a technique whereby a microparticle is affixed at the end of an atomic force microscopy (AFM) cantilever, plays a pivotal role in enabling the measurement of friction at the nanoscale and is of high relevance for applications and fundamental studies alike. However, in conventional experiments, the probe particle is immobilized onto the cantilever, thereby restricting its relative motion against a countersurface to pure sliding. Nonetheless, under many conditions of interest, such as during the processing of particle-based materials, particles are free to roll and slide past each other, calling for the development of techniques capable of measuring rolling friction alongside sliding friction. Here, we present a new methodology to measure lateral forces during rolling contacts based on the adaptation of colloidal probe microscopy. Using two-photon polymerization direct laser writing, we microfabricate holders that can capture microparticles, but allow for their free rotation. Once attached to an AFM cantilever, upon lateral scanning, the holders enable both sliding and rolling contacts between the captured particles and the substrate, depending on the interactions, while simultaneously giving access to normal and lateral force signals. Crucially, by producing particles with optically heterogeneous surfaces, we can accurately detect the presence of rotation during scanning. After introducing the workflow for the fabrication and use of the probes, we provide details on their calibration, investigate the effect of the materials used to fabricate them, and report data on rolling friction as a function of the surface roughness of the probe particles. We firmly believe that our methodology opens up new avenues for the characterization of rolling contacts at the nanoscale, aimed, for instance, at engineering particle surface properties and characterizing functional coatings in terms of their rolling friction.

In Situ Measurement of the Kinetic Friction of Si Nanowires on SiC Substrates in SEM with a Microprobe

Quantitative fitting of nonlinear current-voltage curves and parameter retrieval of semiconducting nanowire, nanotube and nanoribbon devices.

In situ nanomechanical measurement of Cu nanowires

Methodology for Measurement of Submicron Metallic Wire's Local Electrical Conductivity by Applying Four-points AFM Probe Technique

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

Quantitative Measurement of Submicrometre Electrical Conductivity

Measurement Of The Friction Between Single Polystyrene Nanospheres And Silicon Surface Using Atomic Force Microscopy

Measuring Rolling Friction at the Nanoscale

Non-contact Local Conductivity Measurement of Metallic Nanowires Based on Semi-Near-field Reflection of Microwave Atomic Force Microscopy

Conductive-probe Atomic Force Microscopy Characterization of Silicon Nanowire

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

In situ electron microscopy four-point electromechanical characterization of freestanding metallic and semiconducting nanowires

Comprehensive Atomistic Modeling of Copper Nanowires-Based Surface Connectors

Investigating the effect of nanoscale triboelectrification on nanofriction in insulators

Effects of Surface Roughness on the Kinetic Friction of SiC Nanowires on SiN Substrates

Measurement of Interfacial Friction Force of Nanoparticles by Atomic Force Microscope

Imaging the mechanical properties of nanowire arrays

Characterization of Micro-Contact Resistance Between A Gold Nanocrystalline Line and A Tungsten Electrode Probe in Interconnect Fatigue Testing

Novel Method for Convenient Seebeck Coefficient Measurements on Individual Si Nanowires

A New Characterization Approach to Study the Mechanical Behavior of Silicon Nanowires