Abstract:Water-rich fault fracture zone is one of the main factors leading to water and mud inrush in tunnels, which has attracted wide attention of scholars. In order to investigate the fracture and water inrush mechanism of fault surrounding rock under the disturbance of tunnel excavation and water pressure, taking Qilian Mountain Tunnel as engineering background, the fracture of fault surrounding rock caused by tunnel excavation is studied based on the self-developed model test apparatus. The model test system was comprised of a water supply system, acrylic glass holding device, and collection system. The experiment smoothly and successfully reproduced the process of water inrush in front of the tunnel face caused by excavation unloading and water pressure, and the deforming performance and stress distribution of surrounding rock were investigated. According to the experimental phenomena and data analysis, the process of water inrush could be divided into three stages. In the first stage, the tunnel face changed from dry to wet with the tunnel excavation, and the water pressure, soil pressure, and displacement of monitoring points were nearly unchanged. In the second stage, the water seepage area spread to the whole tunnel face from the bottom, and finally water inrush occurred. And the water pressure and soil pressure of monitoring points were increased significantly. At the moment of water inrush, the displacement of monitoring point in fault increased instantaneously; the water-resistant strata have obvious instability characteristics. In the third stage, the water inflow and sand inflow become fewer and fewer over time. And the seepage pressure and soil pressure of monitoring points on the right side of the tunnel decrease firstly and then increase, while the seepage pressure and soil pressure of monitoring points on the left side of the tunnel decrease sharply. The results provide a valuable reference for the mechanism research of water inrush.

Model test system for stability and support of surrounding rock of deeply buried tunnel under complex conditions

Large-burial-depth tunnel surrounding rock stabilization and support model test system under complex conditions

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Development and Application of a Three-Dimensional Geo-Mechanical Model Test System Under Hydro-Mechanical Coupling

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling

DEVELOPMENT OF LARGE-SCALE GEOMECHANICAL MODEL TEST SYSTEM FOR TUNNEL CONSTRUCTION AND ITS APPLICATION

Development and Application of the 3D Model Test System for Water and Mud Inrush of Water-Rich Fault Fracture Zone in Deep Tunnels

Geo-mechanical model test on excavation and support of deep tunnel crossing a fault under hydro-mechanical coupled condition

DESIGN AND RESEARCH ON CONCEALED EXCAVATION SYSTEM FOR 3D GEO-MECHANICAL MODEL TEST OF LARGE UNDERGROUND HOUSES

Development and Application of Model Test System for Reconstruction and Expansion of Existing Shallow Single-Hole Tunnel into Twin-Arch Tunnel

A Novel Large-Scale Three-Dimensional Physical Model Experimental System for Deep Underground Engineering

Development and Application of Micro Automatic Excavation Device for Model Test of Underground Engineering

Device and method for measuring water seepage volume in fluid-solid coupling model test

Large-scale geo-mechanical model tests for stability assessment of super-large cross-section tunnel

Large-scale model test for studying the water inrush during tunnel excavation in fault

Physical modelling of deformation and failure mechanisms and supporting effects for a deep-buried tunnel in inclined layered strata

Support System for Tunnelling in Squeezing Ground of Qingling-Daba Mountainous Area: A Case Study from Soft Rock Tunnels

STUDY ON 3D PHYSICAL MODEL TEST OF SEEPAGE OF DEEP-BURIED LONG AND LARGE DIVERSION TUNNEL

Physical Model Study on Brittle Failure of Pressurized Deep Tunnel with Support System

Study of Seepage Generation Technology in Excavation Process Based on 3D Geo-Mechanical Model

Centrifuge modelling of tunnelling below existing twin tunnels with different types of support