Abstract:Numerical modeling of heavily-erbium-doped fluoride fiber lasers is presented. Calculations from the model were compared with all previously reported experimental demonstrations of heavily-erbium-doped fluoride fiber lasers. Commensurate with recent modeling studies, good agreement with the measurements was achieved with the use of scaled-down rate parameters for energy transfer that corresponds to weaker interactions between Er3+ ions. For wavelength-fixed (grating) systems, we show that the measured saturation of the output power results from a combination of changes to the Boltzmann distribution arising from core temperature excursions and pump excited state absorption (ESA). In free-running systems, we show that inter-Stark level transitions that terminate on progressively higher Stark levels within the I-4(13/2) manifold in part describe the non-saturating behavior of the output power at moderate pump levels. The model was used to investigate the influence of dopant concentration, pump wavelength, pump configuration, output coupling and background loss of the fiber on laser performance. In contrast to a number of previous modeling investigations, our results show that the slope efficiency steadily increases with increasing erbium concentration as a result of the reduced rates of energy recycling caused by the weakly interacting Er3+ ions. The highest slope efficiency was obtained for a pump wavelength of 983 nm due to reduced levels of ESA, however, for both free-running and wavelength-fixed arrangements of the laser, pump ESA may ultimately preclude significant power scaling.

Numerical Analysis of 3.92 Μm Dual-Wavelength Pumped Heavily-Holmium-Doped Fluoroindate Fiber Lasers

Numerical Simulation and Optimization of 3.5 Μm Erbium-Doped ZrF4 Fiber Laser Pumped at 655 and 1981 Nm

Numerical Modeling of 3.5 micron Dual-Wavelength Pumped Erbium Doped Mid-Infrared Fiber Lasers

Numerical Analysis for Multi-Position-pumped Double-Clad Fiber Lasers

Numerical Analysis of 2.7 Μm Lasing in Er3+-doped Tellurite Fiber Lasers

Numerical Modeling of Holmium-Doped Fluoride Fiber Lasers

Numerical Modeling and Optimization of Diode Pumped Heavily-Erbium-Doped Fluoride Fiber Lasers

Numerical modeling of multi-point side-pumped mid-infrared erbium-doped fluoride fiber lasers

Numerical Study of a Bi-Directional In-Band Pumped Dysprosium-Doped Fluoride Fiber Laser at 3.2 Μm

Correction to "Semi-Linear All-Polarization-Maintaining Yb-Doped Fiber Laser Oscillator Manifesting Dual Operation Regime at Net Anomalous Dispersion"

Theoretical Modeling of Ho-Doped Fiber Lasers Pumped by Laser-Diodes Around 1.125 $\mu$ M

Theoretical Study and Optimization of A High Power Mid-Infrared Erbium-Doped Zblan Fibre Laser

3-Dimensional heat analysis in short-length Er3+/Yb3+ co-doped phosphate fiber laser with upconversion.

Realization and simulation of high power holmium doped fiber laser for long-range transmission

Correction to “exact Analytical Solution for Raman Fiber Laser”

Optimized design of high power mid-infrared Er3+, Pr3+-codoped ZBLAN fiber laser

Theoretical Study on Cascade Energy-Transfer Pumping Heavily Holmium-Doped Fluoroindate Fiber Laser At-4 Μm with High-Efficiency

Modeling and Optimization of Cascaded Lasing in a Holmium Doped Fluoride Fiber Laser with Efficient Output at 3.92 Μm.

High-power 970?nm semiconductor disk laser: erratum

The Numerical Analyses for Erbium-Doped Superfluorescent Fiber Sources

Modeling and Optimization of Actively Q-switched 2.8 Μm Er3+-doped ZBLAN Fiber Laser