Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

Equal-slope Baud-Rate CDR Algorithm with Optimized Eye Opening.

A 40gb/s PAM4 Baud-Rate CDR with Equal-Slope Algorithm

Hardware-efficient slope-error algorithm based PAM4 baud rate CDR scheme for 40 Gb/s receiver

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

A 16-Gb/s Baud-Rate CDR Circuit With One-Tap Speculative DFE and Wide Frequency Capture Range

A 4x32Gb/s 1.8pJ/bit Collaborative Baud-Rate CDR with Background Eye-Climbing Algorithm and Low-Power Global Clock Distribution

A Half Rate CDR with DCD Cleaning Up and Quadrature Clock Calibration for 20gbps 60ghz Communication in 65nm CMOS.

A 48mw 15-to-28gb/s Source-Synchronous Receiver with Adaptive DFE Using Hybrid Alternate Clock Scheme and Baud-Rate CDR in 65nm CMOS.

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

Breaking the Baud Rate Ceiling of Electro-Optic Modulators Using Optical Equalization Technique

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

A 0.002-mm 6.4-mW 10-Gb/s Full-Rate Direct DFE Receiver With 59.6% Horizontal Eye Opening Under 23.3-dB Channel Loss at Nyquist Frequency

10 Gbit/s Serial Link Receiver with Speculative Decision Feedback Equaliser Using Mixed-Signal Adaption in 65 Nm CMOS Technology

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

A 30mw/channel 4&#x00d7;25gbps Baud-Rate Bang-Bang CDR Using an Integrating Receiver Based Data Sampling

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology