Abstract:Fill factor (FF) is a determining parameter for the power conversion efficiency (PCE) of organic solar cells (OSC). So far, nonfullerene (NF) OSCs with state-of-the-art PCEs exhibit FFs <0.8, lower than the values of Si or perovskite solar cells. The FFs directly display the dependence of photocurrent on bias, meaning that the competition between charge extraction and recombination is modulated by internal electric potential (Vin). Here, we report a study to understand key parameters/properties affecting the device FF based on seven groups of NF-OSCs consisting of widely used PBDBT-2F or PTB7-Th donors and representative NF-acceptors with FFs ranging from 0.60 to 0.78 and PCEs from 10.27 to 16.09%. We used field-dependent transient photocurrent measurements to reveal that fast and field-insensitive charge extraction at low Vin is an essential prerequisite for obtaining high FFs (0.75–0.8), which is enabled by balanced charge transport in steady and reduced bimolecular charge recombination in high purity phases. With bias-dependent quantum efficiency analysis, we further show that the recombination loss at low Vin in the devices with low FFs tends to be more significant involving excitons generated in the donor phase of blends. Our results provide relevance for how to improve the FF toward the boost of photovoltaic performance in NF-OSCs.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c09123?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c09123</a>.Calculation methods of physical parameters; energy level of materials; EQE spectra; normalized photocurrent decay kinetics; τext versus FF characteristics; TPC and TPV measurements; dark J–V characteristics of single-carrier devices; illumination-dependent open-circuit curves; AFM images; and bias-dependent EQE spectra (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c09123/suppl_file/am0c09123_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Comparative study on fill factor of PERC Silicon Solar cells and Al-BSF Silicon solar cells under non-standard test conditions

Comparative Study on Temperature Coefficients of Al-BSF Solar Cells and PERC Solar Cells

Temperature Coefficients and Operating Temperature Verification for Passivated Emitter and Rear Cell Bifacial Silicon Solar Module

Comprehensive Analysis of Solar Cell Efficiency: A Comparative Study of TOPCon and PERC Photovoltaic Modules under Different Light Intensity Conditions

Preventing the Formation of Voids in the Rear Local Contact Areas for Industrial-Type PERC Solar Cells

Recombination Behaviour of Passivated Emitter and Rear Cell (PERC) Bifacial Silicon Solar Module under Different Illuminations

EFFECT OF TEMPERATURE ON PERFORMANCE PARAMETERS OF MULTICRYSTALLINE SILICON SOLAR CELLS AND MODULES

Investigation on bifaciality factor and ideality factor of PERC bifacial solar module under different irradiances

Influence of the Structural Differences Between End-of-life Al-BSF and PERC Modules on the Al Leaching Separation Behavior

STUDY THE EFFECTS OF SPECTRUM AND SOLAR CELL PARAMETER ON FILL FACTOR

The Effect Of Non-Uniform Illumination On The Performance Of Conventional Polycrystalline Silicon Solar Cell

On the understanding of energy loss and device fill factor trade-offs in non-fullerene organic solar cells with varied energy levels

Insight into Al–Si Interface of PERC by Kelvin Probe Force Microscopy

Numerical study of mono-crystalline silicon solar cells with passivated emitter and rear contact configuration for the efficiency beyond 24% based on mass production technology

Effect of Temperature on Ideality Factor for PERC Monofacial Crystalline Silicon Solar Module

Influence of Al2O3/SiNx Rear-Side Stacked Passivation on the Performance of Polycrystalline PERC Solar Cells

Effect of the Back Surface Topography on the Efficiency in Silicon Solar Cells

Investigation on temperature dependence of recent high-efficiency silicon solar modules

Recombination Parameters of the Diffusion Region and Depletion Region for Crystalline Silicon Solar Cells under Different Injection Levels

Fast Field-Insensitive Charge Extraction Enables High Fill Factors in Polymer Solar Cells

Improved performance on multi-crystalline silicon solar cells by optimizing aluminum back surface field process