Abstract:& nbsp;Considering electrical control of electrostatic precipitation, this paper discusses particle collection in terms of corona ionic wind, gas flow pattern and high-voltage power sources. Experiments and simulations were conducted with lab-scale and industrial electrostatic precipitators. In general, a larger electrostatic precipitator (ESP) index value leads to better ESP performance. To maintain the voltage, simulation results show that a three-phase power source could operate at a lower ripple factor of 0.8% and a shorter recovery time of 5 ms after spark-over than single-phase or high frequency transformer rectifiers. For an industrial ESP with several electric fields, optimal voltage or electric field strength drops from its inlet to outlet fields. It is normally around 3.3 kV cm(-1) with a large corona input power for the inlet field, and it drops to about 2.3 kV cm(-1) with a small input power to limit ionic wind induced reentrainment for the last field. For a typical Chinese 660 MW coal-fired boiler with a fourfield colder-side ESP, its outlet ash concentration and its PM10 and PM2.5 are usually around 15 mg m(-3), 12 mg m(-3) and 2 mg m(-3), respectively. According to particle image velocimetry observation and particle collection measurements, we found that the corona wind generated vortex can result in not only enhancement of collection but also particle reentrainment and/or the so-called 'bypass flow'. An optimum electric field inside the ESP exists to save energy and collect particles. For present ESPs, a higher electric field (>3.5 kV cm(-1)) generates strong electrohydrodynamic flow, which consequently undermines the collection due to turbulent flow. Advanced industrial automatic voltage controllers for three-phase transformer rectifier and double-wire ESPs have been developed according to those experimental results for both reducing emission and corona energy consumption.

A electrostatic precipitator device for high temperature coal gas

Electrostatic dust removing device for high-temperature coal gas

Analytical Method for Particle Collection in a High-temperature Wire-cylinder Electrostatic Precipitator

Electrical Control of Electrostatic Precipitation

Recent Progress of Dry Electrostatic Precipitation for PM 2 . 5 Emission Control from Coal-fired Boilers

Application of key technology changing bag filter to electrostatic precipitator in ultra-low emission upgrading projects of coal-fired power plants

3D numerical simulation of particles collection in a high-temperature wire-cylinder electrostatic precipitator

Convective Heat Transfer Enhancement by Corona Discharge in a Wire–cylinder Electrostatic Precipitator with the Water-Cooling System

Experimental Study on Electrostatic Removal of High-Carbon Particle in High Temperature Coal Pyrolysis Gas

Electrostatic Precipitation under Coal Pyrolysis Gas at High Temperatures

Particle Capture in a High-Temperature Electrostatic Precipitator with Different Electrode Configurations

Research Progress and Application Prospect of High Temperature Electrostatic Precipitation Technology

Experimental Study on Electrostatic Precipitation of Low-Resistivity High-Carbon Fly Ash at High Temperature

Coal -fired flue gas sulfur trioxide removing device

Temperature / many intensive compound electrostatic dust collection system of wet regulation and control

Experimental study on cement kiln dust removal by high-temperature electrostatic precipitator

System for realizing efficient removal of fine particles in high-temperature gas through electrofiltration coupling

Enhanced High-Temperature Particle Capture Through an Electrostatic Precipitator with Assistant Electrodes

Particle trap effect-based dust collection polar plate and high-efficiency electrostatic dust collector

A Combined Wet Electrostatic Precipitator for Efficiently Eliminating Fine Particle Penetration

Numerical Investigation of Particle Re-Entrainment Mechanism and Its Suppression Strategy in the High-Temperature Electrostatic Precipitator