Abstract:A low-frequency angular acceleration rotary table (LFAART) is capable of sinusoidal motion around a fixed position and essential to verify dynamic characteristics of a gyroscope device. The table’s performance at different swinging frequencies and amplitudes needs to be calibrated to realize traceability. However, there has been little research on the LFAART calibration. Besides, the existing measurement methods of sinusoidal angular motion parameters are not adequate for the needs of the LFAART calibration in terms of measurement range, precision, and feasibility. This article presents a calibration scheme combining an optical shaft encoder and a laser triangulation sensor. When the rotation amplitude covers sufficient slots of the scale grating, the optical shaft encoder is applied, while the laser triangulation sensor is used for a tiny amplitude motion. An algorithm is proposed to accurately calculate the angular acceleration amplitude and frequency of the rotation utilizing sinusoidal phase-modulated signals of the optical shaft encoder output. Singular zero-crossings of the series are discarded, and intervals of reversing moments are recognized according to the signal derivative’s sign at remaining zero-crossings. Then intervals are divided into subintervals to obtain accurate reversing moments. Finally, angular displacements between two adjacent reversing moments are estimated based on the fringe counting method, and the amplitude and frequency are calculated. The measurement uncertainty analysis and experiment demonstrate that the calibration scheme, including the algorithm, possesses high accuracy and resolution, wide range, and good operability, which perfectly solves the rotation’s angular acceleration amplitude and frequency.

A Multi-Orientation Low-Frequency Rotational Accelerometer.

A high-precision mechanical absolute-rotation sensor

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

A Laser Walk-off Sensor for High-Precision Low-Frequency Rotation Measurements.

An Aluminum Nitride-Based Dual-Axis MEMS In-Plane Differential Resonant Accelerometer

Two-Dimensional Low-Frequency Optical Accelerometer With High Accuracy and Low Cross-Axis Sensitivity

Development of a High-Precision and Low Cross-Axis Sensitivity 3-D Accelerometer for Low-Frequency Vibration Measurement

Angular Accelerometer Based on a Dual-Polarization Fiber-Optic Sagnac Interferometer.

A Novel Permanent Magnetic Angular Acceleration Sensor

Simple low-frequency optical fiber accelerometer with large rotating machine monitoring applications

Biaxial Angular Acceleration Sensor with Rotational-Symmetric Spiral Channels and MEMS Piezoresistive Cantilevers

An Accelerometer with Integrative Intensity-Modulated Optical Encoder and Patterned Leaf Spring for Low-Frequency Vibration Monitoring

A Differential Resonant Accelerometer with Low Cross-Interference and Temperature Drift

A Resonant Z-Axis Aluminum Nitride Thin-Film Piezoelectric MEMS Accelerometer

A MEMS Resonant Accelerometer for Low-Frequency Vibration Detection

In-plane Dual-axis MEMS Resonant Accelerometer with A Uniform Sensitivity

A Calibration Scheme With Combination of the Optical Shaft Encoder and Laser Triangulation Sensor for Low-Frequency Angular Acceleration Rotary Table

A Novel Single-Axis MEMS Tilt Sensor with a High Sensitivity in the Measurement Range from 0∘ to 360∘

Rotating cantilever-based low-frequency double-fiber grating acceleration sensor

A Continuous Dual-Axis Atomic Interferometric Inertial Sensor

Resonant MEMS Accelerometer with Low Cross-Axis Sensitivity—Optimized Based on BP and NSGA-II Algorithms